Assembly of recovery tank and solution tank, Assembly – Sears 175 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
ASSEMBLY OF RECOVERY TANK
AND SOLUTION TANK
See Fiptre 2
1
,
2
,
Place Recovery Taiik into Solution Tank (align the word
"VACUUM" on Recovery Tank with "VACUUM" on
Solution Tank) and secure with Metal Latch.
Insert the plug on the Shor t Cord from the Solution Tank
into the Recovery Tank Power Head.
ASSEMBLY OF HOSE, WANDS,
NOZZLE AND SOLUTION TUBING
See Figure 1
1. Assemble the two Straight Wands.
2. Assemble the upper Straight Wand to the Angled Wand
of the Hose.
3.
Assemble the Floor Nozzle to the lower Straight Wand.
NOTE; Be sure locking button engages properly when
assembling straight wands, angled wand, and floor
nozzle.
4. Push the Solution Tube Qukk-Disconnect Nutonto Trig
ger Valve. Twist clockwise to lock.
See DETAIL "A"
-
Figure 3.
5. Push Solution Tube into Retaining Clips on Wands, Tub
ing may be wrapped around Wands to take up excess
slack.
6. Attach the Vacuum Hose to Recovery Tank inlet
(Vacuum Inlet).
7. Push solution tube quick disconnect nut onto the quick
disconnect valve. Turn clockwise so valve posts lock into
notches in nut.
See DETAIL "B" - Figure
3.
NOTE: To remove metal retaining dips from hose and solution
tube, scjueeze tube vnth fingers before remomng, Clips mil dislodge
easily. Also squeeze tube before reattaching dips to prevent hose
punctures.
SOLUTION TUBE QUICK
DISCONNECT NUT
QUICK DISCONNECT
VALVE
DETAIL "B”