In-line fuel filter (see fig. 18), Cleaning, Customer responsibilities – Sears 917.252541 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CUSTOMER RESPONSIBILITIES
ENGINE OIL FILTER (See Fig. 17)
Replace the engine oil filter every season or every other oil
change if the tractor is used more than 100 hours in one
year.
•
Drain oil from engine crankcase (See *TO CHANGE
ENGINE OIL” in this section of this manual, through
step remove drain plug).
•
Remove oil filler and wipe off filter adapter.
•
Apply a thin coating of new engine oil to the rubber
gasket on replacement oil filter,
•
Install replacement oil filter on filter adapter. Turn oil
filter clockwise until rubber gasket contacts the filter
adapter, then tighten filter an additional 1/2 turn.
•
F'". crankcase with new oil (See ‘TO CHANGE EN
GiNE 31L” in this section of this manual). For approxi
mate capacity see "PRODUCT SPECIFICATIONS” on
page 3 of this manual.
« Start the engine and check for oil leaks. Correct any
leaks before placing engine into full operation.
IN-LINE FUEL FILTER (See Fig. 18)
The fuel filter should be replaced once each season If fuel
filter becomes clogged, obstructing fuel flow to carburetor,
replacement is required.
•
With engine cool, remove filter and plug fuel line
sections.
•
Place new fuel filter in position in fuel line with arrow
pointing towards carburetor.
•
Be sure there are no fuel line leaks and clamps are
properly positioned.
•
Immediately wipe up any spilled gasoline.
CLEANING
•
Clean engine, battery, seat, finish, etc, of all foreign
matter.
“ Keep finished surfaces and wheels free of all gasoline,
oil, etc.
•
Protect painted surfaces with automotive type wax
We do not recommend using a garden hose to clean your
tractor unless the electrical system, muffler, air filter and
carburetor are covered to keep water out Water in engine
can result in a shortened engine life.
FIG. 17
19