Front wheel toe-in/camber, To remove wheel for repairs {see fig, 27), To start engine with a weak battery (see fig. 28) – Sears 917.252541 User Manual
Page 23: Service and adjustments
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
TO ADJUST STEERING WHEEL ALIGNMENT
(f Steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straightforward, remove steer
ing wheel and reassemble per instructions in the Assembly
section of this manual.
-
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not adjustable on
your tractor. If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center/department.
TO REMOVE WHEEL FOR REPAIRS
{See Fig, 27)
•
Block jp xle securely,
•
Remove axle cover, retaining ring and washers to allow
wheel removal (rear wheel contains a square key - Do
not lose),
•
Repair tire and reassemble,
•
On rear wheels only: align grooves in rear wheel hub
and axle. Insert square key,
•
Replace washers and snap retaining ring securely in
axle groove.
•
Replace axle cover .
WASHERS
RETAINING
RING
AXLE COVER
^SQUARE KEY
(REAR WHEEL ONLY)
FiG. 27
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 28)
A
CAUTION; Lead-acid batteries gener
ate explosive gases. Keep sparks, flame
and smoking materials away from bat
teries. Always wear eye protection
when around batteries.
If your battery is too weak to start the engine, it should be
recharged If "Jumper cables” are used for emergency
starting, follow this procedure:
IMPORTANT:
YOUR TRACTOR IS EQUIPPED WITH A
12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHiClE
MUST
ALSO
BE
A
12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES,
TO ATTACH JUMPER CABLES -
•
Connect each end of the RED cable to the POSITIVE
(+) terminal of each battery, taking care not to short
against chassis,
•
Connect one end of the BLACK cable to the NEGA
TIVE (-) terminal of fully charged battery.
•
Connect the other end of the BLACK cable to good
CHASSIS GROUND, away from fuel tank and battery,.
TO REMOVE CABLES, REVERSE ORDER -
•
BLACK cable first from chassis and then from the fully
charged battery,
» RED cable last from both batteries.
POSITIVE TERMINAL
______\
NEGATIVE TERMINAL
CHASSIS-
■ CABLES
CHARGED
BATTERY
POSITIVE
TERMINAL
NEGATIVE
terminal
FIG. 28
23