Sears 758.14451 - Manual (Page 8)

Using Your Humidifier
Step1 :
Be sure linii is full of water and plugged in.
Step.'2'.. ■'V'';'
Set the Fan selection switch to the desired
- farispeed.V / \ ..
Step 3
Set Humidity Control to medium position.
NOTE: Humidifier should operate with
humidity control on the recommended
MEDIUM setting, if it does not, the humidity
is at a relatively high level. To test the unit
under this condition, turn Humidity Control
all the way to MAX and unit should begin to
operate. After unit has been tested, set
Humidity Control to MEDIUM or desired
level.
Allow 24 hours for humidifier to adjust.
If humidity level in home is sufficient, the
humidifier will only operate with Humidity
Control set on maximum.
IMPORTANT: Water damage may result if
condensation starts to form on windows
or wails. Humidity Control setting should
be lowered until condensation no longer
forms.
Step 4
If humidifier stops running, the humidity
level is at the normal requirements for that
setting or it is adjusting to the home condi­
tions; The table below shows approximate
relative humidity percentages which cor­
respond to the various settings of the
Humidity Control.
When Outdoor
Temperature is:
Recommended
Indoor Relative
Humidity is:
-10°F 20%
OT 25%
10°F 30%
20T & above
35%
Operating Tips for Best Performance
1. Position the humidifier at least 2 inches
from any wail and away from any heat
registers .
2. Do not restrict airflow from entering or
exiting the humidifier.
3. Use Sears recommended bacteriostat
42-Н490У to retard bacteria growth that
may cause odors and may bp harmfiJl to
your health
4. Regular cleaning as instructed in the
"Cleaning of Humidifier” section of this
manual is recommended.
5. Replacement of the evaporative wicklng
fitter at least once per humidification
season or more depending on water
conditions in your area.