Sears 680.84973 - Manual (Page 4)

DO NOT PLUG IN ELECTRIC CORD UNTIL
BRUSHES OR OTHER ÁCCESORIES HAVE BEEN
ATTACHED AND SWITCH HAS BEEN PLACED
IN THE "OFF" POSITION.
HANDLE,
SWITCH BOX AND CORD
1. Place Lower handle tube (Fig. 1) into handle
tube socket "Á" (Fig, 2). Fasten using bolt "B"
and internally threaded nut "C" (Fig, 3) provided
In hardware package.
If the handle tube is difficult to assemble
(tight), insert blade of screwdriver into slot
(Fig. 4) at rear of handle tube socket and twist
screwdriver gently while inserting handle tube,
2. Place upper half handle tube (Fig. 1) over
lower half. Align holes and fasten with remaining
bolt "B” and internally threaded nut "C”.
3. Attach switch box to rear of upper handle
tube. Place switch box tab (no hole) into
rectangular hole (Fig. 5). Position box against
handle tube. Fasten using the small screw
provided in the hardware package. DO NOT
OVERTIGHTEN,
4. The motor cord, which goes from the switch
box to the bottom of the unit, is attached in
two (2) locations behind the dispenser at top
and bottom. The upper part of the motor cord
is snapped into place alongside the upper cord
hook on the dispenser top (Fig 6).
The lower part of the motor cord is snapped
into place between the two lower cord hooks.
They are located on the dispenser base (Fig. 7).
5. Attach lower plastic hose to rear of unit by
inserting the fitting on the end of hose into
the hole located midway at rear of unit (Fig. 8).
6. The electric cord is wound around cord hooks
as illustrated in (Fig. 9).
Note: All moving parts requiring lubrication
have been permanently lubricated at the
factory.
ASSEMBLY
INSTRUCTIONS
LOWER
HANDLE '**¥‘*'1 t r*"
I
UESt
UPPER
J HANDLE
TUBE
FIG. 1
52^
J
0
0
FIG. 4
FIG. 6
I o
rlu« /
^ B
FIG. 3
FIG. 5
FIG. 7
FIG. 9