Sears 680.84973 - Manual (Page 5)

DISPENSER
1. Raise dispenser top "A” (Fig. 10). Position
dispenser "F” in base "B”.
2. Press top dispenser firmly against the handle
tube "G" Valve stem "C” must be above valve
lifter "D*' (Fig. 11).
3. Slide dispenser top "A” down so that it
engages the dispenser and holds it securely in
position.
To dispense the liquid, pull trigger "E”
momentarily and intermittently. Liquid will
flow as long as the trigger is raised.
Note: If the dispenser fails to discharge liquid
when the trigger is raised all the way, tilt the
dispenser away from the handle tube. Take a
pair of long-nosed pliers and grasp the valve
lifter "D".
Bend the two projections (tabs) at the same
time upward until a dime fits snuggly between
the bottom of the valve stem X” and the top
of the valve lifter "D” (Fig. 11),
If liquid continues to flow when the trigger Is
released, grasp the valve lifter close to the
handle and bend the two projections downward
until a dime fits snuggly between the bottom
of the valve stem an the top of the valve lifter.
DISPENSING SYSTEM MUST BE THOROUGHLY
CLEANED lAAMEDiATELY AFTER EACH USE. DO
NOT STORE LIQUID IN DISPENSER.
Remove dispenser from unit and empty. Rinse
thoroughly with warm water. The dispensing
system must be flushed immediately after use.
Partially fill dispenser with warm water, mount
on unit an then dispense all the water into a
receptacle placed under the unit.
BRUSHES
ELECTRIC CORD PLUG SHOULD ALWAYS BE
DISCONNECTED FROM THE ELECTRICAL OUTLET
BEFORE ATTACHING, REMOVING OR CHANGING
BRUSHES.
1. Lay the polisher flat exposing the underside
of the unit (Fig. 12). Using a rotating motion push
the brush on the spindle as far as it will go.
2. After each use remove brushes vdth a slight pull.
3. Wash in warm soapy water after each use.
Shake out excess water. Stand bristles on paper
towel to dry.
DO NOT USE HOT WATER.
DO NOT FORCE DRYING BY USING AN OVEN OR
RADIATOR HEAT.
4. Remove brushes from the machine when not
in use to extend the life of the brush.
PADS
electric CORD PLUG SHOULD ALWAYS BE
DISCONNECTED FROM THE ELECTRICAL OUTLET
BEFORE ATTACHING, REMOVING OR CHANGING PADS.
1. To attach pads on Shampooer / Polisher;
push the ends of the adapters (provided in the
hardware package) through the holes in the
pads, then snap adapters on to the Scrubbing
Brushes, DO NOT attach to Shampoo Brushes,
2. Pads may be cleaned If desired in warm
soapy water. Rinse thoroughly. Stretch out to
shape and allow to dry.