Cobra Electronics MICROTALK CXR825 - Manual (Page 10)

Customer Assistance Warranty Introduction
15
Operation
14
Mode Functions
Operation
To recall a stored memory channel location:
1. Press the Mode button until the Memory icon
and the memory location number flash on the
display.
2. Press the Channel Up or Channel Down button
to select a memory location
(0 through 9).
If a location has been programmed before,
its associated channel/privacy code will be
shown on the display.
3. Press the Talk button to return to Standby mode
on the selected memory location.
A memory location can be reprogrammed at
any time it is displayed. Press the Lock/Enter
button to begin.
While recalling a stored memory location,
if you do not press any buttons for 15 seconds, your
radio will automatically return to Standby mode
on the channel/privacy code displayed before you
entered mode functions.
6. Choose one of the following:
a. Press the Channel Up or Channel Down
button to select a CTCSS privacy code
(01 through 38) for the channel.
b. Press the Lock/Enter button to
switch from CTCSS to DCS. The DCS
icon and privacy code numbers will
flash on the display. The Channel Up
or Channel Down button can then be
used to select a DCS privacy code
(01 through 104) for the channel.
If “OFF” flashes in place of the privacy
code numbers, a privacy code is
already set in the opposite (CTCSS
or DCS) system. Press the Channel Up or
Channel Down button to cancel
the opposite code and select a privacy
code from the active system for the
selected channel.
7. Choose one of the following:
a. Press the Lock/Enter button to enter
the channel/privacy code in the selected
memory location. Radio then proceeds to next
memory location, which will blink.
b. Press the Mode button to
enter the channel/privacy code in
the selected memory location and
proceed to other functions on the channel/
privacy code displayed
before you entered mode functions.
c. Press the Talk button to enter the channel/
privacy code in the selected memory location
and exit mode functions. Upon release of the
Talk button, the
radio will enter Standby mode on the channel/
privacy code just entered.
Mode Button
Channel Buttons
Memory Icon