Cobra Electronics MICROTALK CXR825 - Manual (Page 14)

23
Mode Functions
22
VibrAlert and Call Alert
•
Your microTALK radio can alert you to incoming signals by sounding an
audible call tone, by vibrating silently or both.
To change call settings:
1. Press the Mode button
until the Call Setting icon
flashes on the display.
The current setting (“01”
vibrate + ring, “02” vibrate
only or “03” ring only)
is displayed.
2. Press the Channel Up or
Channel Down button to
change the call setting.
3. Choose one of the following:
a. Press the Mode button
to enter the new setting
and proceed to other functions.
b. Press the Lock/Enter button to enter the new
setting and return to Standby mode.
Operation Customer Assistance Warranty Introduction Operation
During memory location scan (while receiving an Incoming
transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on that memory
location.
b. Your radio will remain on that memory location and return to
Standby mode. Press the Channel Up or Channel Down button to
resume scanning memory locations.
c. After 10 seconds of inactivity, unit starts scan again.
If you press the Talk button while scanning, but more than
10 seconds after receiving a transmission, you will transmit on
the memory location on which, during scanning, you last received
a transmission.
If you do not press any button within 10 seconds, your radio
will automatically resume scanning memory locations.
During memory location scan (while not receiving a transmission),
you can choose from the following:
a. Press and hold the Talk button to communicate on the channel/
privacy code that was displayed before you entered mode
functions or memory location on which, during scanning, you last
received a transmission.
b. Press the Mode button to proceed to other functions.
c. Press the Lock/Enter button to return to Standby mode
on the channel/privacy code that was displayed before you entered
mode functions or the memory location on which, during scanning,
you last received a transmission.
To reduce the number of memory locations being scanned,
you may de-program any unwanted locations. (See page 16
to de-program a memory location.)
Mode Button
Channel Buttons
VibrAlert + Ring
VibrAlert Only
Ring Only