Sears 580.32601 - Manual (Page 12)

FILL FUEL TANK
1. Pull back on knurled fitting and remove fuel
line from tank filler cap.
2. Remove Fuel Tank filler cap. Fill tank with
CLEAN,
FRESH, NON-LEADED gasoline.
(Leaded, REGULAR grade gasoline is an ac­
ceptable substitute.) Reinstall cover.
A
DANGER
Gasoline vapors are highly flammable and
explosive. Avoid spillage. Do not permit
smoking, open flame, or sparks in the area
while filling fuel tank.
INSTALL FUEL TANK
1. Set Fuel Tank into place on alternator
cradle. Pass rubber strap UNDER fuel tank lif­
ting
handles and hook into both strap
brackets.
CORD SETS FOR 120 VOLT, 15 AMP OUTLETS
Extension cords used with the two 120 volt,
15 amp outlets must be in good condition.
Wire gauge sizes of cord sets must be large
enough to handle the amperage load of tools
and equipment they power. The chart at right
lists recommended wire sizes for cord sets,
based on the amperage of equipment being
used and the length of the cord in feet.
10
1, Disconnect^^“^^^'"“'“^——
“Fuel Line ..
2. Remove Filler Cap
KNURLED FITTING
MALE FITTING
TANK FILLER CAP
/
2. To connect fuel line quick-disconnect to
tank fitting, pull back on quick-disconnect
knurled fitting. Insert open end of knurled fuel
line fitting over male fitting on tank, then let
knurled fitting snap into place to lock.
AMPERAGE
RATING LENGTH OF CORD lU FEET
SQ Ft too Ft ISO Ft.
2 18 Ga IBGa. 18 Ga
3 18 Oa 18 Ga, IBGa
A 16 Ga 16 Ga 16 Ga
5 16 Qa 16 Ga. 16 Ga
6 16 Ga 16 Ga, 14 Ga
8 16 Ga 14 Ga 12 Ga
10 16 Ga 14 Ga 12 Ga
12 14 Ga 14 Ga 12 Ga
14 14 Ga 12 Ga 10 Ga
16 12 Ga 12 Ga 10 Ga