Sears 175.867029 - Manual (Page 10)

TROUBLE SHOOTING CHART
PROBLEM POSSIBLE SOLUTIONS*
1. NeKher vacuum motor nor pump
motor runs.
1. Be sure power switch is in “ON” position.
2. Be sure power cord is plugged in securely.
3. Check wall electrical outlet (by plugging in a known
working electrical appliance).
2. Vacuum motor runs, but there is no
spray at the nozzle.
1. Be sure Electrical Cord from Power Head to Solution
Tank is securely plugged into receptacle on the Power
Head.
2. Check that Solution Tank is full.
3. Be sure Pump Switch is in the “HI" or "LO" position.
4. Nozzle Ports may be clogged. See illustration below to
unclog.
3. Spray from the floor nozzle comes
out of one side of the nozzle only.
1. Undog the Nozzle Port. See illustration below.
4. Motor runs but cleaner does not pick
up solution from carpet (no exhaust
friim top of cleaner).
1. Recovery Tank is full of dirty water and must be emptied,
2. Check for clogged hose or nozzle. Clogscould resuftfrom
picking up material such as carpet strings, shoe laces,
etc.
S. Spray connections leak. 1. Disassemble nut at leaking connection. Be sure washer
is properly seated. Reassemble and tighten securely.
* If the "Possible Solutions” to ‘'Problems" listed inthe chart do not correctthe problem, take your cleaner to a Sears
Service Center for professional sen/tce. Repairs not listed in this chart require professional and specific
knowledge of this modal cleaner and could result In safety hazards and personal injury if not made by a
qualified Sears Service Technician.
TO UNCLOG NOZZLE PORT
See Figurs 16
1. Insert the point of a needle or pin into
Spray Port to uncbg.
NOTE; Do not let the point of needle or pin
touch any part of the Spray Pad surface or
Spray Pad will not spray solution properly.