To empty the solution tank, Dry vacuuming, Jeig.:-ll – Sears 175.867029 User Manual
Page 8: Operation, Additional uses
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
TO EMPTY THE SOLUTION TANK
See Figure 11
When cleaning is completed, both the Recovery Tank and the
Solution Tank should be emptied pnorto storage. Empty the
Recovery Tank as described eariier. There are three methods
of emptying the Solution Tank.
Method 1:
1. Disconnect Pump Cord from Recovery Tank.
2. Remove Recovery Tank from Solution Tank and pour
solution out of the RIter Opening-
Method 2:
1. Place Roor Nozzle in bath tub or container.
2. Depress Solution Release Trigger and spray until empty.
Method 3:
1. Remove Floor Nozzle and insert Wand into Solution Tank
through the Riler Opening,
2. Vacuum solution out.
3. All solution Is now in Recovery Tank. Empty Recoveiy
Tank as descrtt>ed earlier
METHOD!
METHOD 2
METHODS
JEig.:-ll
ADDITIONAL USES
DRY VACUUMING
See Figure 12
Your Cleaner comes with a disposable paper dust bag to trap and collect dirt when used for dry pick up. It is very important
that the disposable paper dust bag remain clean to allow air to pass through it while trapping dirt. If the dust bag is over filled
or its pores become dogged from fine powders, no air can pass through. This greatly reduces the efficiency of your cleaner
and could cause the dust bag to burst. To maintain your cleaner's peak efficiency, check the disposable paper dust bag often
and replace when clogged or approximately one half full.
TO INSTALL DUST BAG
1. TURN POWER SWITCH OFF AND DISCONNECT
POWER CORD FROM ELECTRICAL OUTLET.
2. Lift Latches and remove Power Head from Unit.
3. Grasp Cardboard Collar of Dust Bag and push Collar as
far as possible onto Bag Adapter Tube. NOTE: For
greater ease In assembly, slide bottom of Cardboard
Collar onto Adapter Tube first, then pull top of Collar over
Adapter Tube.
4. Position Dust Bag around sides of tank to allow motor
assembly to fit back into unit.
5. Bend top flap of Cardboard Collar inward.
6. Replace Power Head on unit, aligning the word
■VACUUM' with Hose Inlet on Recovery Tank as
shown
in Rg. 10. NOTE; Be careful not to crush Dust Bag or to
deform flexible splash plate on Power Head when
assembling,
7. Unplug Short Power Cord from Recovery Tank Power
Head. fSee Figure 2, page 4)
CAUTION: PAPER DUST BAG IS FOR DRY PICK UP
ONLY. DO NOT USE WHEN VACUUMING UP WATER OR
OTHER LIQUIDS!