Sears 831.287602 - Manual (Page 6)

5. Plug the Power Cord (70) into ttie ja<^,at the,back of
^ bike. Test the console in the follqwing'rriannen^l^;'^^ '
A. Plug the transformer on №e Power Cord (70) into a 120-vqIt j,
outlet: ■ ■■ ■ ■ '.......
B. Press the power button on the console (see the drawing at the
top of page 9). The manual mode indicator will light and the
LCD display will appear. Next, move the manual resistance
control. You will hear the motor as the resistance changes.
Next, press the program/manua! button. The program mode
indicator and the eight segment indicators will light.
if the console does not function as described, see assembly step
4, Make sure that the wire is plugged correctly into the wire
harness.
6. Slide a 5/8" Spacer (57) and a 5/8" Handlebar Spacer (76) onto
each side of the handlebar shaft of the Frame (11). The open side
of each 5/8" Spacer (57) must be turned toward the Frame.
Slide the Left and Right Neck Shields (67,68) onto the handlebar
shaft of the Frame (11). Insert the four 3/4" Phillips Screws (4)
into the Left Neck Shield, and tighten them into the Right Neck
Shield.
7. Slide a Handlebar (9) onto the left side of the handlebar shaft of
the Frame (11). Tap a 5/8" Plastic Cap (3) onto the handlebar
shaft. '
Attach the other Handlebar in the same manner (not shown).
8. Insert a 5/16" x 1 3/4’ Bolt (36) through the lower end of the left
Handlebar (9). CAUTION: The lower end of the Handlebar may
have a rough edge. Be careful to avoid cutting your fingers.
Tap a Link Arm Bushing (58) into a Link Arm (37). Slide the Link
Arm onto the Bolt. The flange of the Link Arm Bushing must be
turned toward the Handlebar, and the opening in the end of the
Link Arm must be downward as shown. Tighten a 5/16“ x 18 Nut
(17) onto the Bolt. Do not overtighten the Nut; the Link Arm must
pivot freely. Clip the Link Arm onto the lock rod.
Attach the other Link Arm to the right Handlebar in the same
manner (not shown).