Sears 831.287602 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
9. Hold one of the Pedal Shafts (38) with the included tool as shown—the tool must be betwe^en the coils of the
Pedal Spring (52). Using an adjustable wrench, remove the 1/2* Nylon Lock Nut (46) from the end of the Pedal
Shaft (There is an 11/16* Spring Washer (51), a Pedal Spring (52), an 11/16" Washer (54). a Pedal Bushing
(55), a 9/16" Washer (56) and a 9/16" Pedal Spacer (75) on the Pedal Shaft.) Using the included tool, firmly .',; V
tighten the Pedal Shaft, in a clockwise direction, into one of the arms of the Crank (27). While holding the Pedal
Shaft witti the tool, use an adjustable wrench to tighten the M2' Nylon Lock Nut (46) onto the end of the Pedal
Shaft. (There is aS/16" Washer (65) and a 5/16".Pedal Nut (49) on the other end of the Pedal Shaft. The 5/16"
Pedal Nut (49) must be flush with the end of the Pedal Shaft.) Press a Pedal Cap (50) into the Pedal (10).
Attach the other Pedal Shaft to the other arm of the Crank in the same manner (not shown).
50
49 65