Sears 831.297452 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5. SYMPTOM; THE WALKING BELT IS OFFCENTER OR SLIPS WHEN WALKED ON
a. If the walking belt has shifted to the left, first remove the safety
key and UNPLUG THE POWER CORD. Using the 3/16” alien
wrench, turn the left rear roller adjustment bolt clockwise, and
the right boit counterclockwise, 1/4 of a turn each. Be careful not
to overtighten the walking belt. Plug in the power cord, insert the
safety key and run the treadmill for a few minutes. Repeat until
the walking belt is centered.
b. If the walking belt has shifted to the right, first remove the safety
key and UNPLUG THE POWER CORD. Using the 3/16” alien
wrench, turn the left rear roller adjustment bolt counterclockwise,
and the right bolt ckx;kwise, 1/4 of a turn each. Be careful not to
overtighten the walking belt. Plug in the power cord, insert the
safety key and mn the treadrnill for a few minutes. Repeat until
the walking belt is centered.
c. If the walking belt slips when waiked on, first remove the safety
key and UNPLUG THE POWER CORD. Using the 3/16” alien
wrench, turn both rear roller adjustment bolts clockwise, 1/4 of a
turn. When the walking belt is correctly tightened, you should be
able to lift each side of the walking belt 3-4 indies off the walking
platform. The center of the walking belt should just touch the
walking platform. Be careful to keep the walking belt centered. Plug
in the power cord, insert the safety key and run ftie treadmill for a
few minutes. Repeat until the walking belt is properly tightened.
6. SYMPTOM: THERE IS A NOTICEABLE DIFFERENCE IN THE INCLINE RANGE OF THE TREADMILL
a. Raise the incline of the treadmill to its maximum height and continue to press the incline button for three
seconds. This will recalibrate the incline system.
STORAGE
Unplug the power cord when the treadmill is not in use.
Using the 7/32” alien wrench, remove the bolt from the upper end of
each upright (see drawing 1). Rotate the handrails down.
Remove one bolt and washer from the lower end of each upright (see
drawing 2). Loosen the oftier bolt in the lower end of each upright.
Carefully lower the uprights.
Remove the upright bushing from each side of the treadmill frame
(see drawing 3). Keep the hardware in a secure location.
It is recommended that the treadmill be covered during extended peri
ods of storage.
12