Assembly instructions, To remove chipper-shredoer from carton, Tools required for assembly – Sears 247.799892 User Manual
Page 5: How to set-up your chipper-shredder, Attaching the chute deflector, Attaching the catcher bag
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY INSTRUCTIONS
IMPORTANT:
This
unit
is
shipped
WITHOUT
GASO
LINE
or
OIL.
After
assembly,
see
operation
section
of
this
manual
for
proper
fuel
and
engine
oil
recommen
dations.
NOTE:
To determine right and left hand sides of your
chipper-shredder,
stand
behind
and
face
the
hopper
(engine is at the front of the unit).
Your
chipper-shredder
has
been
completely
assem
bled
at
the
factory,
except
for
the
chute
deflector
and
the
catcher
bag.
A
pair
of
safety
glasses
are
also
included in the carton.
TO REMOVE CHIPPER-SHREDOER FROM CARTON
Cut
the
corners
of
the
carton.
Remove
all
packing
inserts.
Roll
chipper-shredder
out
of
the
carton.
Make
certain
all
parts,
literature
and
the
safety
glasses
have
been removed before the carton is discarded.
TOOLS REQUIRED FOR ASSEMBLY
(2) 7/16" or Adjustable Wrenches
HOW TO SET-UP YOUR CHIPPER-SHREDDER
Spacers
(Inside
Hinge)
Hex Boit
Chute
Deflector
FIGURE 1.
A
MAKE
CERTAIN
THE
SPARK
PLUG
WIRE IS DISCONNECTED AND MOVED
AWAY
FROM
THE
SPARK
PLUG
BEFORE
ASSEMBLING
THE
CHIPPER-
SHREDDER.
■ATTACHING THE CHUTE DEFLECTOR
•
Remove
the
hand
knobs
and
cupped
washers
from
each
side
of
the
discharge
opening
on
the
left
side
of the shredder.
•
Remove the hex lock nut, two spacers and hex bolt
from inside the hinge on top of the discharge open
ing. Do not remove one spacer from the hex bolt.
•
Place
the
chute
deflector
in
position
on
the
dis
charge
opening.
Insert
bolt
through
hinge
on
chute
deflector and housing (spacer fits inside hinge).
•
Place
second
spacer
over
the
hex
bolt,
inside
the
other
part
of
hinge.
Secure
with
hex
lock
nut.
Tighten securely.
•
Secure
both
sides
of
the
chute
deflector
to
the
housing
using
hand
knobs
and
cupped
washers
(cupped
side
of
washers
go
against
chute
deflec
tor).
ATTACHING THE CATCHER BAG
Your
chipper-shredder
is
equipped
with
a
catcher
bag
to catch the shredded material.
• To attach bag, place bag opening over the chute
deflector so it completely covers chute opening.
Depress plunger on drawstring, pull on drawstring
until bag is tight around chute opening. Release
—plunger to lock it into position. See figure 2.