Sears 831.159231 - Manual (Page 6)

10. Press a 1 1/2" x 1 1/2" Inner Cap (19) into the Ab Arm
(21). Wet the upper end of the № Arpi and the inside
of the Ab Arm Pad (25) with soapy water. Slide the
Pad onto the Ab Arm.
Tap a 1/2" Dome Cap (24) onto one end of the 3" "D"-
Axle (23). Liberally grease the /Vxle. Align the Ab Arm
(21) with the bracket on the Ab Frame (3). Insert the 3"
*D"-Axle into the Ab Frame and the Ab Arm. Tap a 1/2“
Dome Cap (24) onto the other end of the Axle.
Attach the Lower Cable (76) to the Ab Arm (21) with
the 3/8"
X 2 1 / 4 " Bolt (22) and a 3/8" Nylock Nut (6).
Do not overtighten Nut. The cable should swivel
freely.
11. Liberally grease the axle on the Stabilizer (2), Slide a
Pedal Spacer (16) onto the left axle, with the open
side of the Spacer turned toward the Stabilizer. Make
sure there are two Large Bushings (15) in the Left
Pedal (10). Slide the Left Pedal onto the left axle. If the
Left Pedal is on correctly, the Pedal Cover (12) will be
on lop and the slotted bracket will be turned toward
the Stabilizer. Tap a 3/4" Dome Cap (14) onto the axle.
Assemble the Right Pedal (11) in the same manner.
12. Liberally grease the axle on the Frame (1). Slide a
Cylinder Spacer (42) and a Resistance Cylinder (39)
onto the right axle. Tap a 5/8" Dome Cap f40) onto the
axle. Attach the other Resistance Cylinder in the same
manner.
Rest the Left and Right Pedals ( 1 0 , 1 1 ) orl the
brackets at the lower ends of the Resistance Cylinders
(39). Make sure the brackets are in the same slots in
both Pedals.
13. Press a 1 1/2" x 1 1/2" Inner Cap (19) into the Seat
Support (4). Liberally grease the 1/2" x 2 3/4" Axle
w/Hal Cap (59). Attach the Leg Lever (58) to the Seat
Support (4) with the Axle and the 1/2" Hat Cap (60).
Center one Pad Tube (56) in the Seat Support (4) and
one in the Leg Lever (58). Wet the ends of the Pad
Tubes and the Insides of the Small Foam Pads (57)
with soapy water. Slide the Pads onto the Pad Tubes.
14. Attach the Seat (54) to the Seat Support (4) with two
1/4" x 3/4" Bolts (8) and two 1/4" Lock Washers (7).
Insert the 1/2“ x 2 3/4" Clevis Pin (55) into either the
high or low hole in the Frame (1). insert the Hairpin
Cotter (90) into the Clevis Pin. Slide the Seat Support
(4) onto the Clevis Pin.