Operation and adjustment – Sears 831.159231 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
!5. Separate the ends of the Control Stand (29) and slide
the Plastic Sleeve (30) onto one end. Bring the ends
together and center the Plastic Sleeve between them.
Plug one end of the Control Cord (27) into the Hand
Control (28). Plug the other end of the Cord into the
Wire Adapter (74) at the front of the system.
Attach the Hand Control (28) to the Control Stand (29)
with the two 1/2" Tap Screws (31).
Plug the Power Cord (26) into the socket at the back •
of the system.
OPERATION AND ADJUSTMENT
Plug the transformer on the power cord into a 120-volt outlet. Keep the power cord away from
walkways and heated surfaces. Turn on the power when using the system, or the system could be
damaged. When you are finished using the system, always unplug the transformer.
DIAGRAM OF THE HAND CONTROL
1. Low/High Range Indicator—Shows when the system is
set at minimum or maximum weight.
2. Weight Display—Displays the current weight setting.
3. Power Button—^Turns the power on and off.
4. Weight Decrease Button—Decreases the weight.
5. Weight Increase Button—Increases the v/eight.
TURNING ON THE POWER AND RESETTING THE SYSTEM
Press the power button. IMPORTANT: Each time the pov/er Is turned on, the system must be reset
before the weight can be changed. The v«reight display will read ”E--." To reset the system,
press the weight increase or decrease buttons until the display reads "H250” (maximum weight)
or "L30" (minimum weight).
CHANGING THE WEIGHT SETTING OF THE SYSTEM
The weight can be changed from a minimum of 30 pounds, up to a maximum of 250 pounds, in incre
ments of 1 pound. To increase the weight, press the weight increase button. To decrease the weight,
press the weight decrease button. The buttons can be held down to change the weight quickly.
IMPORTANT: To prevent damage to the system, do not put any tension on the system while
changing the weight. Do not push on the butterfly arms, ab arm or leg lever. If the lat bar Is
attached to the system, it may be helpful to support the weight of the lat bar with one hand. The
system motor will emit a sound to alert you while the weight is being changed.