Warning: for your own safety, never, Installing the chuck, Assembly – Sears 113.21371 User Manual
Page 6: Caution: the, Press, Installing the
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
assembly
WARNING: FOR YOUR OWN SAFETY, NEVER
CONNECT PLUG TO POWER SOURCE OUTLET UNTIL
ALL ASSEMBLY STEPS ARE
COMPLETED.
1.
Unwind the power cord.
2.
Make sure the quill lock handle is tight.
3.
Stand on'the left side of the drill press and LOOSEN
the HEAD LOCK HANDLE.
4.
Raise the HEAD about HALF WAY up the column.
CAUTION: THE
HEAD
WEIGHS ABOUT 65 POUNDS
DROPPING THE HEAD ACCIDENTLY COULD CAUSE
PERSONAL INJURY OR DAMAGE THE
DRILL
PRESS.
5.
TIGHTEN the Head Lock Handle.
6.
Position
the
HEAD-SUPPORT
COLLAR
underneath
the
head
and
tighten
the
TWO
BOLTS
using
a
Vz"
wrench.
IN
ORDER
TO
RAISE
THE
HEAD
TO
A
HIGHER
POSITION,
IT
WILL
BE
NECESSARY
TO
INSTALL
SEVERAL PARTS.
INSTALLING THE
CHUCK
1.
Clean
out
the
TAPERED
HOLE
in
the
chuck;
clean
the
spindle
nose
with
a
clean
cloth.
Make
sure
there
are
no
foreign
particles
sticking
to
the
surfaces.
The
slightest
piece
of
dirt
on
the
spindle
nose
or
in
the
chuck
will
prevent
the
chuck
from
seating
properly.
This
will
cause
the drill to "wobble."