Sears 758.14808 - Manual (Page 4)

Cas^rlnitáílÉtkm
Step1
Reference the unpacking instructions on
the upper carton f%)S of the shipping car­
ton your Kenmore humidifler was received
in. The casters and hardware are inside
the humidifier cabinet
Step 2
Carefully place your humidifier upside
down on a soft surface such as a rug or
carpet. Locate the screw holes on the bot­
tom comers of the cabinet
Location Instructions
WARNING
For your own safety, do not use
humidifier if any parts are damaged
or missing.
Step 1
Place humidifier in area of house where
most humidity is needed, or one which
would likely result in moist air being circu­
lated throughout the house such as near a
cold air return. Moist air (humidity) pro­
duced will disperse into the v\^ole house,
but area closest to unit will have the high­
est humidity.
Electrical Hook-Up
—
Step 1 ,
Locate nearest 120V A.C. wall socket in
the location desired, preferably on inside
wall.. Plug in the electrical cord.
NOTE: Only two of the four holes in the
caster plate will align for proper caster
installation.
steps
Each csßter should be attached with two
(2) screws placed diagonally from each
other. Turn the unit upright and you will be
ready to position your humidifier in the
location of your choice.
Water Fill
WARNING
To avoid shock, always unplug
humidifier before filling, cleaning, or
servicing.
Step1
Raise the hinged access lid and note the
location of the controls towards the rear of
the humidifier (Figure 3).
Step 2
The humidifier may be positioned with the
back (cord exit side), or left side (side
opposite hinged lid) flush to the wall, or
away from the wall. Air needs to enter
through louvers in the hinged access lid in
order for humidifier to operate at peak effi-
dency.
NOTE: Due to release of cool, moist air
from humidifier, it is best to direct air
away from home thermostat. It is best
to position humidifier next to an Ínstete
wall. Hot air registers and cold air from
outside wails can affect the efficiencies
of the controls. Unit should not be
placed where warm air from a hot air
register blows directly on unit.
WARNING
To avoid fire or shock hazard, humidi­
fier, should be plugged into a 120V
A.C. outlet. Do not use extension
cords.
HINGED
ACCESS
LID
Figure 3
CONTROL
AREA
FULL
INDICATOR
LABEL