General, Motor, Arm bearings – Sears 113.23611 User Manual
Page 16: Maintenance
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
maintenance
WARNING; FOR YOUR OWN SAFETY, TURN SWITCH
“OFF", REMOVE KEY AND REMOVE PLUG FROM POWER
SOURCE OUTLET BEFORE MAINTAINING OR LUBRI
CATING YOUR SAW.
GENERAL
An occasional coat of paste wax on the work table will allow
the wood being cut to glide smoothly across the work surface.
MOTOR
If the power cord is wortt, cut, or damaged in any way, have
it replaced immediately.
Do not attempt to oil the motor bearings or service the motor
internal parts.
ARM BEARINGS
Lubricate the arm bearings after 10 hours of use. Re-oil after
every 50 hours of use or whenever there is a squeak coming
from the bearings. Four plastic bearing caps are provided with
this saw. Add SAE 20 oil into each cap and then snap cap onto
arm bearing. Leave caps on bearings for overnight and then
remove and store caps for later use.
ALTERNATE METHOD OF OILING BEARINGS IF
RE-OIL CAPS ARE LOST.
1. Turn saw on its side.
2. Squirt a generous amount of SAE 20 oil around the shaft
end and bronze bearing.
3. Let the oil soak in overnight in this condition.
4. Next day; repeat the above procedure tor the opposite side
of the saw.