Sears 113.23611 - Manual (Page 17)

wiring diagram
SWITCH
recommended accessories
Item
Leg Set
Blades
Sears Number
9-22244
See Catalog—For 5" long,
pin end type blades
9-26873—medium radius cuts in wood up to Vh” thick
9-26879—fine radius cuts in wood up to V 4 " thick
The above recommended accessories are current and were
avaitable at the time this manual was printed.
trouble shooting
glossary of terms
for woodworking
1. Kerf— the slot cut by the blade
2. Leading Edge—the edge of the work piece which is
pushed into the blade first.
3. Sawbtade Path—The area of the workpiece directly
in line with and moving toward the sawblade edge.
4. Blade Tooth Sef—the distance that the edge of the
sawbtade tooth is bent {on set) outward from the side
of the blade.
5. Trailing Edge—the workpiece edge last cut by the
sawblade.
6. Work Piece— the item on which the cutting operation
is beina preformed. _______
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH “OFF”,
REMOVE KEY AND REMOVE PLUG FROM POWER SOURCE
PROBLEM PROBABLE CAUSE
REMEDY SUGGESTED
Breaking Blades. 1. Wrong tension.
2. Over working blade.
3. Wrong blade application.
4. Twisting blade in wood.
1 . Mjust blade tension.
2. Reduce feed rate.
3. Use narrow blades for cutting thin wood, wide
blades for thicker wood.
4. Avoid side pressure on blade.
Motor will not run. 1. Defective cord or plug.
2. Defective motor.
1 , Replace defective parts before using saw again.
2. Consult Sears Service. Any attempt to repair this
motor may create a HAZARD unless repair is done
by a qualified service technician. Repair service is
available at your nearest Sears Store.
Vibration
NOTE; There wilt always
be some vibration present
when the saw is running
because of the motor
operation.
1. Improper mounting of saw.
2. Unsuitable mounting
surface.
3. Loose table or table
resting against motor.
4. Loose motor mounting
1. See mounting instructions in this manual for proper
mounting technique.
2. The heavier your work bench is the leæ vibration
will occur. A plywood workbench wilt not be as good
a work surface as the same size solid lumber. Use
common sense in choosing a mounting surface.
3. Tighten table lock knob.
4. Tighten motor mounting screws.
Blade Runout—Blade not
in-line with arm motion Blade holders not aligned 1. Loosen cap screws holding blade holders to arms.
Adjust position of blade holders—Retighten holders.
17