Sears Craftsman 536.886531 - Manual (Page 14)

OPERATION
A
CAUTION: NEVER RUN ENGINE
INDOORS OR IN ENCLOSED,
POORLY ycijTji ATcn AREAS
ENGINE
EXHAUST CONTAINS
CARBON MONOXIDE, AN ODORLESS AND
DEADLY GAS. KEEP HANDS, FEET, HAIR AND
LOOSE CLOTHING AW AY FROM ANY MOVING
PARTS ON ENGINE AND SNOW THROWER.
WARNING: TEMPERÄTUREOF MUFFLER AND
NEARBY AREAS MAY EXCEED 150° F, AVOID
THESE AREAS.
DO NOTALLOW CHILDREN OR YOUNG TEEN-
riOKDATIK AD DD KIDAD QKIAW
THROWER WHILE IT IS OPERATING.
On gravel or crushed rock surfaces, set the skids at
1-1/4" below the scraper bar (see To Adjust Skid
Height paragraph on page 18), Stones and gravel
must not be picked up and thrown by the machine,,
Alter the snow throwing job has been completed,
aliow the engine to idle for a few minutes, which wilt
melt snow and accumulated ice off the engine
Cleanthe snow thrower thoroughly aftereach use
Remove ice and snow accumulation and all debris
from the entire snow thrower, and flush with water
(if possible) to remove ail salt or other chemicals
Wipe snow thrower dry
A
CAUTION: DO NOT ATTEMPT TO RE­
MOVE ANY ITEM THAT MAY BECOME
LODGED IN AUGER WITHOUT TAKING
THE FOLLOWING PRECAUTIONS:
• RELEASE AUGER DRIVE AND TRACTION
DRIVE LEVERS.
» MOVE THROTTLE LEVER TO STOP POSI­
TION.
® REMOVE (DO NOT TURN) IGNITION KEY.
e DISCONNECT SPARK PLUG WIRE.
« DO NOT PLACE YOUR HANDS IN THE
AUGER OR DISCHARGE CHUTE. USE A
PRY BAR.
SNOW THROWING TIPS
e For maximum snow thrower efficiency in removing
snow, adjust ground speed, NEVER the throttle
Go slower in deep, freezing, or wet snow If the
track slips, reduce fon«ard speed The engine is
designed to deliver maximum performance at full
throttle and should be run at this power setting at all
limes.
® Most efficient snowthrowingisaccomplished when
the snow is removed immediately after it falls,
® For complete snow removal, slightly overlap each
path previously taken.
• The snow should be discharged down wind when­
ever possible
• For normal usage, set the skids so that the scraper
bar is 1/8” above the skids For extremely hard-
packed snow surfaces, adjust the skids upward so
that the scraper bar touches the ground
14