Sears QUICK GRIP PULSE 831.29788 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SOLUTION: a. Use only a single-outlet surge suppressor that is UL1449 listed as a transient voltage surge sup­

pressor (TVSS). The surge suppressor must have a UL suppressed voltage rating of 400 volts or
less and a minimum surge dissipation of 450 joules. The surge suppressor must be electrically
rated for

120

volts AC and 15 amps.

'

'

' '

b. If the walking belt is overtightened, treadmill perfor-

- mance may decrease and the walking belt may be

permanently damaged. Remove the key and UN­

PLUG THE POWER CORD. Using the alien wrench,

turn both rear roller adjustment bolts counterclock­
wise, .1/4 of a.tom. When the walking belt is properly

tightened, you should be able to lift each side of the
walking belt 3 to 4 Inches off the walking platform. Be
careful to keep the walking belt centered. Plug in the
pow^r cord, insert the key and run the treadmill for a
few minutes. Repeat until tlie walking belt is properly

tightened.

c. If the walking belt still slows when walked on, please call our toll-free HELPLINE.

PRORLPM: Thft walking belt slows when walked on

PROBLEM: The walking belt Is off-center when walked on

SOLUTION: a. If the walking belt has shifted to the left, first remove

the key and UNPLUG THE POWER CORD. Using
the alien wrench, turn the left rear roller adjustment
bolt clockwise, and the right bolt counterclockwise,

1/4 of a turn each. Be careful not to overtighten the

walking belt Plug in the power cord, insert the key

and run the treadmill for a few minutes. Repeat until.

the walking belt is centered.

b. If the walking belt has shifted to the right, first remove

the key and UNPLUG THE POWER CORD. Using
the alien wrench, turn the left rear roller adjustment

bolt counterclockwise, and the tight bolt clockwise,
1/4 of a turn each. Be careful not to overtighten the

walking belt. Plug in the power cord, insert the key
and run the treadmill for a few minutes. Repeat until
the walking belt is centered.

PROBLEM: The walking belt slips when walked on

SOLUTION: a. if the walking belt slips when walked on, first remove

the key and UNPLUG THE POWER CORD. Using'
the alien wrench, turn both rear roller adjustment

bolts clockwise, 1/4 of a turn. When the walking belt
is correctly tightened, you should be able to lift each
side of the walking belt 3 to 4 Inches off the walking
platform. Be cáreful to keep the walking belt centered
Plug In the power cord, insert the key and run the

treadmill for a few minutes. Repeat until the walking

belt is properly tightened.

15

Advertising