Sears QUICK GRIP PULSE 831.29788 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3.
5.
With the help of a second person, hold the Console Base
(
6
) and the Right Handrail (32) near the right Upright (14)
as shown. Route the Console Wire Harness (92) through
the bracket on the Right Handrail.
Refer to the inset drawing. Slide the Strain Relief Clip
(
88
) onto the Console Wire Harness (92). Make sure that
there is no slack in the Console Wire Harness between
the Strain Relief Clip and the Console Base (
6
). Insert a
3/4’ Screw (91) into theiStrain Relief Clip arid into theln-'
dicated hole In the Right-Handrail (32). Tighten the Screw
Into the Console Base.
4. With the help of a second person, hold the.Pulse
Handrail (99) near the right Upright (14) as shown. Route
the 30“ and 9’ Pulse Wires (97, 95) through the bracket
on the Right Handrail (32).
Connect the Console Wire Harness (92) to the Upright
Wire Harness (96). Connect the 30’ and 9’ Pulse Wires
(97,95) to the Upright Wire Harness (92). Make sure that
the wires with tags are connected to each other. Refer to
. the inset drawing If needed.
Insert all wires into the right Upright (14). Insert the
bracket on the Right Handrail (32) into the right Upright
(14). Make sure that the wires are not pinched.
Attach the Pulse Handrail (99) to the Left and Right
Handrails (2.32) with two Pulse Handrail Bolts (98) and
Handrail Washers (16).
6.
Attach the Gorisbie Base (
6
) to the Left and Right
Handrails (2,32) with three 3/4’ Screws (91).
^92~
—14
* ..*f;
•/