CLIFFORD AUTO SECURITY User Manual
Page 12
Feature
Factory
setting
# of
momentary
presses
Secondary
action
Program
completion
confirmation
Result
Add a New
Remote to
Channel 2
(optional
remote
accessory)
—
9
Press remote control button 2
within 10 seconds.
2 LED
Flashes
Button 2/channel 2 code
of the new remote control
has been memorized
Add a New
Remote to
Channel 3
(optional
remote
accessory)
—
10
Press remote control button 3
within 10 seconds.
Button 3/channel 3 code
of the new remote control
has been memorized
Headlight
Duration
15
Seconds
11
See Programming the Headlight “ON” Duration on page 9.
Adding New Remote Controls
Your Remote Keyless Entry System will respond to as many as four Clifford
3-button/3-channel remote controls. To obtain additional remotes, contact any
Authorized Clifford dealer. You can also easily program these remotes into the system
yourself. To add a new remote control to your system, use the procedures noted in the
Programming User-Selectable Features section on pages 10-11.
How to Erase the Codes of Lost or Stolen Remote Controls
If one of your remote controls is ever lost or stolen, you can erase its digital codes from
the system memory to make sure that the missing remote control can never be used to
unlock your system. Just use the Add a New Remote Control to Channel 1-2-3
procedures noted in the Programming User-Selectable Features section on pages 10-11
for a total of four times (e.g., if you have one remote control remaining, program it four
times; if you have two remote controls, program each twice).
Example
To change the Automatic (“passive”) SelfLocking Door feature from its factory
setting of “OFF” to “ON,” you would do the following:
Turn the ignition key to the “ON” position.
Enter your valet code. The switch’s LED will light to indicate that the sys-
tem is in programming/valet mode. Then immediately tap and release
the momentary side of the PlainView switch 5 times.
Wait 3 seconds. The switch’s LED will flash once to confirm the successful
programming of this feature.
That’s all there is to it!
© Copyright Clifford Electronics, Inc., 1995 31-131-G/RKESOM/495