CLIFFORD AUTO SECURITY - Manual (Page 9)

PlainView Coded Valet Switch LED Indicator
The LED status indicator in the switch is used to communicate the operational status of
your Remote Keyless Entry System system:
LED Condition Meaning
Off Doors are unlocked, you may enter the vehicle.
On System in valet or programming mode.
One Flash Confirms successful programming of a system feature.
Two Flashes Confirms successful programming of a remote control button.
Flashing Doors are locked and system is protecting your vehicle.
UltraSecure Coded Valet Mode
Whenever your vehicle is to be washed, serviced or valet parked, you must put the
system in valet mode if the automatic Starter Interrupt and SelfLock features are
enabled.
To enable valet mode
1. Turn the ignition switch to its “ON” position or start the engine.
2. Enter your secret valet code on the PlainView switch, then return the switch to its
center position.
3. You now have 3 seconds to press the latched position (valet mode). Once you
have entered valet mode, the system’s LED will glow continually for ongoing
visual confirmation of valet mode.
Keyless entry in valet mode: Even if valet mode is enabled, you can still
remotely control the convenience features. For instance, simply press button 1
as you normally would to unlock the doors. The doors will unlock (as
indicated by one flash of the parking lights) and the interior lights will
illuminate. Press button 1 again and the doors will lock (as indicated by two
flashes of the parking lights), but the starter interrupt feature will not engage,
so the vehicle may be driven by anyone with the car key. You can also use the
remote control’s other button to activate options such as a remote trunk release
or remote engine starting.
To exit valet mode
1. Turn the ignition switch to its “ON” position or start the engine.
2. Flick the switch back to its center position. The LED will turn off to confirm that
the system is now in its normal operating mode.
8