Hunter 28837 46 Pemberley - Manual (Page 7)

Installation
12-13
Heating Systems Selector
The heating system seJector is a switch on the Printed Circuit Board, The switch is at "HG" position. Leave it In
this position if you have a gas furnace or an oil burner.
If you have an eiectn'c furnace, check to see if the heat comes on when called for and that the blower fan will also
come on. If either do not, then change the switch to the “HE” position, if the heat and fan come on normally as
expected, then leave the switch in the "HG” position. The system selector has no effect in the cooling mode.
HG HE
V
Ù
Connect Wires and. Mount Tbermostat Coyer
-4 Match and connect the labeled wires to the
I
appropriate coded terminal screws on the
mounting plate (Figure 4). Ignore any wires which may
on the mounting plate, matching letter codes to wire
colors (See Figures 3 and 4). Connect battery lead
connectors (Figure 5),
be present, but which were not connected to your old
thermostat Do not connect these to your Thermostat.
2 Push excess wire back into hole to prevent
interference with mounting of Thermostat cover.
3 Insert the batteries into your Thermostat as
shown in Figure 5, observing the polarity marked
on the unit,
4 Make sure the HEAT - OFF - COOL switch is In
OFF position and FAN - AUTO switch is in AUTO
position. Push all the connectors at the end of each
thermostat wire onto the appropriate spade terminals
5 Line up the thermostat cover with wallpiate,
snap the thermostat to the wall plate,
6 Switch on the main power. Press the reset
button to reset and start the clock. Use a thin
probe such as a straightened paper clip to push
gently the reset button through the hole in the front
panel (Figure 6). The-LCD display should read 12:00
MO and show the current room temperature of your
house. If it shows random numbers, or partial
digits, press the reset button once again,
if you haven't already done so, remove the mylar
label from the display window^ 7
Spade Terminal
"'I fST'. I
Figure 4
Battery
Figure 6