Hunter 27187 Original Fan/Light Control - Manual (Page 2)

Transmitter Installation:
-1. Install a 9 volt battery inside the hand-heid transmitter after setting
the dip switches to match the dip switches in the receiver.
2. Mount the remote holder over the ceiling fan's wall switch using
the existing wall plate screws. Refer to Figure 6.
3. The transmitter can be placed on the remote holder for convenience
or safekeeping.
Operation;
1. Turn ON wall switch, the light will turn ON at maximum brightness.
2. Light Operation:
• Press and quickly release the light button on the hand held remote
to turn the light OFF or ON. (Light will come ON at low brightness.)
• Press and hold the light button for more than 1 second to turn the
light ON and increase from low to maximum brightness.
• Release the light button when the desired light level is reached.
• Continue to hold the light button to repeat the cycle.
(OFF-light level increase-High)
• While the light is ON, holding the light button will increase the light
brightness.
• Turning the light OFF resets the dimming function. The next press
of the light button will start at low brightness.
The light button glows in the dark for easy nighttime operation.
3. Fan Operation:
• Press the fan speed button to turn ON the ceiling fan at High speed.
Press again to change the speed to Medium, then again to Low.
• Press the fan OFF key to turn the ceiling fan OFF.
For best fan operation: Allow the ceiling fan motor to start on High,
then select the desired speed.
4. Manual Light Switch Operation:
To turn the lights ON without the transmitter, turn OFF the wall
switch for 5 seconds, then turn the wall switch back ON. The light
will turn ON at maximum brightness, and the fan will be OFF.
For everyday operation, leave the wall switch ON. However, if the
control will not be used for an extended period of time (5 days or
more), turn the wall switch OFF.
For more information on Hunter Fan products, visit our website: www.hunterfan.com
1 Troubleshooting I
Symptom Possible Causes Solution
1. No functions operate. Main Power not restored. Replace fuse.Turn ON circuit breaker. Turn ON wall
switch.
.
Fan pull chain not set to High. Turn OFF power at wall switch or main electric panel.
Set fan to High speed.
Light puil chain not set to ON. Set light kit to ON.
Receiver wiring incorrect. Verify wiring connections.
Transmitter and receiver dip switches do not match. Set transmitter and receiver to same dip switch setting.
Battery too weak. Replace with new, alkaline battery.
2. Operates only at close range. Cable or power lines in ceiling run over fan. Re-orient any cables or wires.
Battery too weak. Replace with new, alkaline battery.
3. Inconsistent operation. Signal partially blocked from reaching receiver. Extend antenna into ceiling box, or move it for better
reception.
RF interference. Turn OFF wall switch for 5 seconds, then turn back ON.
Continuing RF interference. Change dip switch settings to a different code in both
Transmitter and Receiver.
HUNTER FAN COMPANY ORIGINAL'' CONTROL LIMITED WARRANTY
The Hunter Fan Company makes the following limited warranty to the original purchaser of the Original® Control (“Control"): Your Control Is warranted to be 'free from defects
in material and workmanship for a period of one year from the date of sale. If the Control malfunctions or fails within the warranty period due to a defect in material or
workmanship we will replace it free of charge. IF THE ORIGINAL PURCHASER CEASES TO OWN THE CONTROL, THIS WARRANTY AND ANY IMPLIED WARRANTY, INCLUDING
BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE VOIDED. THIS WARRANTY IS IN LIEU OF ALL
OTHER EXPRESS WARRANTIES. THE DURATION OF ANY IMPLIED WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE, IN RESPECT TO ANY CONTROL, IS EXPRESSLY LIMITED TO THE PERIOD OF THE EXPRESS WARRANTY SET FORTH ABOVE FOR
SUCH CONTROL. This warranty excludes malfunctions or failures which were caused by repairs by persons not authorized by us, mishandling, improper installation, modifica­
tions, or damage to the Control while in your possession, or unreasonable use. This warranty does not apply to batteries or to deterioration or damage to the product caused by
the use of faulty batteries. To obtain a replacement, return your Control postage prepaid along with proof of purchase to Hunter Fan Company Service Department at 2500 Frisco
Avenue, Memphis, Tennessee 38114, IN NO EVENT SHALL HUNTER FAN COMPANY BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES. SOME STATES DO NOT
ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE
LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY
FROM STATE TO STATE.
©1999, Hunter Fan Company Form 41407 (3/99)