CompuSTAR CM1000-K - Manual (Page 4)

Quick Reference Quick Reference
Valet Mode Valet Mode
When servicing or loaning your vehicle to others, the CompuStar system should be placed in Valet
mode. Valet mode prevents the system from remote starting and disables all alarm functions.
IMPORTANT: While in Valet mode the CompuStar will still lock and unlock power lock systems.
The system can be put into valet with the following procedure;
1. You can put the system into valet by turning the ignition key “on” and then “off” five
times within 7 seconds. The parking lights will flash once to confirm the system is in
valet mode. Shortly after the first flash, the parking lights will flash twice. To exit Valet
Mode you must reprogram your remotes as shown below
Remote Maintenance – Battery Replacement
The only regular maintenance this system requires is remote control battery replacement.
No programming is required when replacing the battery.
One-Way Remote: CM1000-K (R150)
First, remove the small Phillips screw located on the back of the remote. Once the screw has been
removed, gently pull the remote apart being careful to not touch the circuit board. The 1BAMR requires
one 27A battery. These specialty batteries can be purchased from your local CompuStar dealer or an
electronics store.
1 Button Remote Functions
Button Duration
Additional
Installations
Required
Function / Description
0.5
second
No Unlock/disarm the vehicle doors.
2.5
seconds
Yes Activates and opens the power trunk release.
0.5
second
No Lock/arm the vehicle doors.
4