CompuSTAR CM1000-K - Manual (Page 5)

General System Functions General System Functions
The remote transmitter functions have been predetermined and programmed from the factory. The dual
button configuration allows for keyless entry and/or trunk release functionality. Although other
CompuStar systems have numerous button functions and capabilities, please keep in mind that your
system has the option for future upgradeability to an alarm as well as keyless entry system.
The remote transmitter functions have been predetermined and programmed from the factory. The dual
button configuration allows for keyless entry and/or trunk release functionality. Although other
CompuStar systems have numerous button functions and capabilities, please keep in mind that your
system has the option for future upgradeability to an alarm as well as keyless entry system.
Sending Commands Sending Commands
When in range, and the button has been pressed, the remote bright blue LED will illuminate and vehicle’s
parking lights will flash. For example, to the trunk release command from the CM1000-K, hold down the
unlock button for 2.5 seconds. The remote bright blue LED will come on and then flash. When in range, and the button has been pressed, the remote bright blue LED will illuminate and vehicle’s
parking lights will flash. For example, to the trunk release command from the CM1000-K, hold down the
unlock button for 2.5 seconds. The remote bright blue LED will come on and then flash.
Active Lock/Arm and Unlock/Disarm Active Lock/Arm and Unlock/Disarm
Tap the Lock button for 0.5 second to lock/arm and tap the Unlock button unlock/disarm. The
remote bright blue LED will momentarily indicating the signal has been sent to the vehicle. This
feature may require additional programming and/or installation depending on the vehicle. Please check
with your dealer for details.
Remote Trunk Release
Hold the Unlock button for 2.5 seconds to activate the power trunk release. This will allow you to open
your trunk without using the key or button in the vehicle. This feature is not available on every vehicle
and may require additional installation to function. Please check with your dealer for details.
Starter Kill
The optional starter kill feature prevents a thief from starting your vehicle when the doors are
locked/armed. This feature requires additional installation and programming. Please see your dealer for
more details.
Remote Coding / Programming Routine(s)
IMPORTANT: Every CompuStar remote must be coded to the system prior to performing any operations.
Remote coding is typically done at your local CompuStar dealer.
Programming CM1000-K – R150
STEP 1: Activate Valet/Programming mode by manually turning the ignition key on and off (between the
Acc & On positions) five times within 7 seconds. The vehicle’s parking lights will flash once with the
successful completion of this step.
STEP 2: Within a 3 second period after cycling the ignition for the 5
th time, pressing the single button
once for 0.5 seconds. The parking lights will flash once to confirm the transmitter has been coded.
Exiting Programming: Programming is a timed sequence. The parking
lights will flash twice signaling the end of programming mode.
Programming Multiple Remotes: After the confirmation flash given in
step 2, code additional remotes by pressing the single button
on
remote. The parking lights will flash once confirming each additional
remote. All systems can recognize up to three remotes.
5