Hunter 22282 52 Outdoor Original User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STEP 4: ROUGH-IN WIRING
CAUTION: BE CERTAIN THAT ELECTRICITY IS TURNED OFF AT MAIN PANEL BEFORE ANY WIRING IS DONE
A. Bring Electrical cable into octagon box and attach with an approved connector.
Make certain that wiring meets all national and local electrical codes. See Fig. 4.
STEP 5; ASSEMBLY OF FAN AND HANGING FAN ON HOOK
A.
Remove card board sleeve from carton and place on working surface. Carefully set motor into sleeve as shown in Fig. 5.
B.
Feed wires from top of motor through pipe nipple. See Fig. 5.
C.
Thread pipe nipple into fan until tight (at least 4’/2 turns). Thread pipe nipple into hanger bracket
untii tight (at least 3 turns). Tighten setscrew in hanger bracket (alien wrench supplied) and set
screw in motor housing. See Fig. 6.
D.
Place rubber bushing on hook. Lift fan and hook hanging bracket onto pin in rubber bushing. See Fig. 6.
STEP 6: FINAL WIRING AND CANOPY INSTALLATION
A.
Connect electrical supply leads to leads from, motor, using approved connectors.
Ground wire must be attached to ground screw as shown in Fig. 7.
B.
Install split canopy by pressing two halves together around pipe, placing pins
on one half into holes in other half. Screw halves together using two 3/8" long
self-threading screws provided. Allow 1/8" min gap between ceiling and canopy
for fan movement. Use extra screw in center of hub to assist in clamping canopy
to pipe. See Fig. 7.
GAOUMO SCAEW
CEILING
CANOPy HAIP
STEP 7: FAN BLADE INSTALLATION
Blades are shipped in sets matched by weight. A weight mark appears on the back of
each blade. Install blades in sets of matching number, one opposite the other. In some
instances, all blades may have the same weight mark and may be installed in any posi
tion. Replacement blades should be ordered in sets of 2.
Insert a 12-24 Fillister Head Screw (provided) in hole in blade bracket. Use screwdriver
to hold in place. Align blade holes with mtg. holes in hub, by turning screw and re-adjus
ting blade bracket until screw mates with threaded hole.in hub. Repeat for 8 screws.