After threading, take the bobbin case b – SINGER 15-91 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
After threading, take the bobbin case b
3
^ the
latch, holding it between the thumb and forefinger
12
To Replace the Bobbin Case
F
ig
. 10. B
obbi
-
x
C.
vse
T
hiie
.
a
.
ded
and
II
eplaced
of the left hand. Place the bobbin case on the center
stud (B, Fig. 10) of the shuttle bodj^ with the posi
tion finger (A, Fig. 10) opposite the notch at the top
of the shuttle race. Release the latch and press the
bobbin case back until the latch catches the groove
near the end of the stud. Allow about three inches
of thread to hang free from the bobbin case and
close the slide in the bed of the machine.
Advertising