SINGER 15-91 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
13
Select a needle to suit the size of thread being
used. See inside cover page at back of book.
Turn the balance wheel over toward you until
the needle bar is at its highest position, and loosen
the thumb screw (A, Fig. 11) in the' needle clamp.
To Set the Needle
F
k
5. 11. P
ositioning
of
N
eedle
IN N
eedle
C
l
,
vmi
>
Have the flat side of the shank of the
needle toward the left as shown above and
put the needle up into the clamp as far as
it will go. Then tighten the thumb screw.
Advertising