Asus 136-480A - Manual (Page 4)

ASSEMBLY
Step 1. Remove the lawn mower and all parts
from the carton. Make certain that all
loose parts and literature have been
removed before the carton is discarded.
Step 2. Place steering wheel over steering shaft.
Step 3. Secure with Believille washer and hex
nut. See figure 2.
Step 4. Press the cap on the steering wheei by
hand. See figure 2.
Steering Wheel Cap—
Hex Nut-
Belleville Washer ’
■G
■H
FIGURE 2. STEERING WHEEL ASSEMBLY
the Step 5. Your molded seat comes with
mounting bolt molded in the seat.
A. Select one of three hole locations on
seat spring.
B. Place seat on spring and secure with
lockwasher (A) and hex nut (B). See
figures 1 and3.
NOTE
Check ALL nuts and bolts for cor­
rect tightness.
BATTERY INFORMATION
FOR ELECTRIC START
MODELS
A.
B.
\
WARNING (
Battery acid must be handled with great care
as it will blister the skin and damage clothing.
It is advisable to wear goggles, rubber gloves,
and a protective apron when working with it.
Neutralize acid spilled on clothing with dilute
ammonia water or a water solution of baking
soda. If acid gets on clothes, dilute it with
clean water first, then neutralize.
C. If for any reason acid should be spattered in
the eyes, wash it out immediately with clean
cold water. Seek medical aid if discomfort
continues.
D. Since battery acid is corrosive to metals, do
not pour into any sink or drain. Rinse empty
electrolyte containers and mutilate before
discarding.
I DANGER
\
FIGURE 3. SEAT ASSEMBLY
BATTE-RIES CONTAIN SULFURIC
ACID AND MAY CONTAIN EXPLO­
SIVE GASES (when electrolyte has
been added)
A. Keep sparks, flame, cigarettes away.
B. Hydrogen gas is generated during charging
and discharging.
C. Ventilate when charging or using in enclosed
space.
D. When using a charger—to avoid sparks,
NEVER connect or disconnect charger clips to
battery while charger is turned on.
E. Always shield eyes, protect skin and clothing
when working near batteries.