CLIFFORD cyber Arrow 3 - Manual (Page 6)

How to in ter pret the LED status in di ca tor
The LED on your car’s dashboard or console will inform you of the system status:
LED Condition Meaning
Off System is disarmed and in normal operating mode (i.e., valet mode is off)
On Valet mode is on, the vehicle may be entered without having to disarm
Flashing rapidly (ignition off) System is armed and protecting your vehicle
Flashing slowly System is disarmed but the Starter AutoImmobilisation has been engaged (European models only)
Flashes, pause, flashes Either an error (such as arming with the trunk open) or indicates the trigger or sensor that was tripped
Auto mat ic Battery- Saving Mode
To conserve vehicle battery power (the LED actually draws more current than the entire control unit), if the system has remained continuously armed for
48 hours, the flash rate will automatically slow to half the normal rate. After 96 hours, it slows to one-quarter.
User- Selectable AutoLock and Aut oUn Lock™
Some vehicles are incompatible with the AutoLock and AutoUnLock features.
For your safety and that of your passengers, the doors automatically lock the instant you turn on the ignition. When you turn the ignition off,
AutoUnLock automatically unlocks the doors. These are user-selectable features.
Smart trunk re lease op tion
If you have this option, you may use the button to remotely release the trunk latch. The system’s electronic interlock prevents unintentional activation
of the remote trunk release when you drive, or when the system is armed. The Smart Trunk Release feature requires installer programming, so if you have
the optional trunk release installed, you may want to verify that it will NOT activate when the system is armed. If it can be activated while armed, causing the
alarm to sound, please return to your installing Clifford Dealer and have them correct this (it only takes a couple minutes and there will be no charge to you).
Piezo Sen sor
This sensor detects theft-related vibrations/ impacts and triggers the alarm. If needed, sensitivity can be readjusted by any Authorized Clifford Dealer
(preferably your installing dealer). To prevent falsing, system sensor(s) are bypassed when the engine is remotely started (if you have the IntelliStart 4
option). Ask your Authorized Clifford Dealer about the optional dual-zone (full alarm and light-impact warning tone) model of this sensor and other
optional sensors that will further enhance the security of your vehicle, such as:
n Glass Tampering Sensor: Today’s thieves shatter vehicle windows with a small metal punch device that does not create any vibrations for an
impact sensor to detect. The Glass Tampering Sensor detects the sound of glass breaking, and glass tampering attempts, and will trigger the alarm.
n Digital Dual-Zone Proximity Sensor 4: Detects movement inside the passenger compartment and very near the vehicle. If a thief were to lean
into the passenger compartment, the primary zone of this sensor would trigger the full alarm. However, if a thief was lingering very close to your
windows, a warning tone would sound. Since it can “see” through glass and canvas, this sensor is particularly well suited for use in convertibles and
other open or soft-sided vehicles (targa, T-top and Jeep-like vehicles).
n Digital Tilt/Motion Sensor: Detects less than one degree of lifting or any minute motion of the vehicle while completely ignoring all other
conditions that falsely set off all other sensors. Even if you park on a hill, the Digital Tilt/Motion Sensor will accurately respond to the first hint of
tampering to reliably protect your wheels and entire vehicle.
High- Output Si ren
n Remote siren silencing: If triggered by a non-threatening event, you can silence the siren without remotely disarming. Press button while
the siren is sounding. Two chirps confirm that the sensor activated the alarm and the system is remaining armed. Four chirps confirm that the
system is still armed, but that the ignition is on or the hood, trunk or a door is open and that this may indeed be a genuine theft attempt.
n Automatic noise abatement: Alarm sounding is limited to five siren duration cycles even if a door is left open in the wake of an intrusion.
n Long-term chirp silencing: You may silence the arm and disarm chirps on a long-term basis until you decide to restore them. Your vehicle’s
parking light flashes will continue to provide visual confirmation of remote controlled system arming and disarming. See User-selectable features.
n Selectable siren duration (non-European models only*): You may change the factory set 30-second siren duration to 60 or 90 seconds via
the programming procedure or via the CliffNet Wizard software. See User-selectable features.
n Personalized Siren Sounds (requires the Self-Powered SmartSiren 4 option) (non-European models only*): The optional
Self-Powered SmartSiren 4 sounds six different alarm sounds. You may turn any of the six sounds on or off via User-selectable features programming
to create a different combination of sound patterns. So if you hear a siren at a distance, you will know for sure whether it is your car or someone
else’s. See User-selectable features (column 1, row 2). What’s more, with the optional Clif fNet Wiz ard software and Da ta Port Replicator Cable, you
may select up to six sounds from more than a dozen different siren sound choices for truly unique customization.
n Choose when your Per son al ized Si ren Sounds* play: You may choose to have your Per son al ized Si ren Sounds “play” every time the alarm
is set off, or you may set the system to sound them only upon trigger activation. When set to “trigger only” the basic siren wail will sound if a
sensor is activated, but the Personalized Siren Sounds will play if the hood, trunk or a door is opened. See User-selectable features (column 1, row 3).
*Not avail able on Euro pean mod els in com pli ance with EC95/56
6