Britax ADVOCATE - Manual (Page 17)

28 29
BRITAX Child Safety, Inc. ADVOCATE User Guide
2. Pull the lower connector
from the storage slot or
lower anchor.
Top
Tether Configurations
Rear-Facing Tether Connector Strap
Because every vehicle model is different, locations to
anchor the tether for rear-facing installations may vary. Use
the rear-facing tether connector strap to assist in creating an
anchor point for rear-facing configuration “A” (above) .
1. Find a fixed location in the vehicle that is bolted to the
floor. If you cannot find a location to create an anchor
point, contact the vehicle manufacturer to identify a
tether connection point.
2. Route the strap through the anchor point.
3
5
(A) Rear Facing (C) Forward Facing (B) Rear Facing
To attach the lower connector to the storage slot or
lower anchor:
1. Firmly push the lower
connector into the slot or
lower anchor until a click
is heard.
NOTE: The lower
connectors store top
down in the slots.
Using the Energy-Absorbing Versa-Tether
Failure to follow the guidelines below may cause the child
seat not to perform as intended.
• BRITAX recommends that the Versa-Tether be used at
all times when installing the child seat. Using the tether
will improve the stability of your child seat and reduce
the risk of injury.
• Attach the Versa-Tether only to tether anchors identified
by your vehicle manufacturer as tether anchorage
points. Only use the designated tether anchor for each
seating position.
• If your vehicle does not currently have a tether anchor
attachment, refer to your vehicle owner’s manual or
contact your vehicle man u fac tur er for assistance. DO
NOT modify your vehicle without advice from your
vehicle manufacturer.
• Store the Versa-Tether in the pouch on the back of the
child seat when not in use. DO NOT install the child
seat with the Versa-Tether attached to the carry clip.
Tether anchor locations vary from
vehicle to vehicle. Check your vehicle
owner’s manual and look for the tether
anchor symbol shown in the diagram
to help identify where the top tether
anchor points are located in your
vehicle. See the diagrams on page 29
for possible rear and forward-facing
Versa-Tether installation configurations.
3. Thread the metal D-ring
through the loop on the
end of the strap.
4. Pull the metal D-ring
through until the strap is
tight.
5. Use the D-ring as an
attachment point for the
tether.
NOTE: Store the tether
connector strap in the
tether pouch when not in
use.
Versa-Tether
To attach the Versa-Tether to a Tether Anchor:
1. Firmly press the hook
over the tether anchor
point.
2. Pull the loose end of the
webbing to remove slack
from the Versa-Tether.
NOTE: When using as a
carry strap, tighten until
the strap is comfortable to
carry.