CITIZEN CT-S2000L - Manual (Page 31)

— 28 —
5.6 Printing Paper *L
Also refer to the core dimension and notes of “5.2 Printing Paper” in User’s Manual of
standard model. Use print paper shown in the following table or the equivalent.
Paper type Product name
Recommended thermal label paper GG40/P22/G6B from Ojitac, HD75 from Nippon Paper,
150LA-1 from Ricoh
Full cut
position
Paper feeding
direction
Printable area
CAUTION!
Pay attention to the following when using Auto Cutter. Otherwise, a cutter lock or a
cutter failure may occur.
■ Set the cut length of paper to 25 mm or more.
■ When using label paper, cut the gap between labels (liner sheet). Do not cut the label
paper (tack paper).
■ Adjusting the paper sensor must be carried when the type of liner is changed.
Mark Item Dimensions
A Liner width 57.5, 59.5, 79.5,
82.5 + 0.5
B Label width (Size A) -4 + 0.5
C Left edge of label 2 + 0.5
D Print width (Size A) -8
E Top margin 2 + 1
F Print length 21 to 296
G Bottom margin 2 + 1
H Cut position between labels 1/2 x (Size I)
I Gap between labels 4 to 30
J Label length 25 to 300
K Label pitch I+J
L Right margin 2 + 1
M Left margin 2 + 1
Unit: mm
_
_
_
_
_
_
_
φ
102 or less
Label paper thickness* 65 to 85 µm
Liner thickness 60 µm max
Core inner diameter d 25.4mm
Core outer diameter D 32mm
Roll paper specifications
Printing surface a) Label paper