Mounting and powering the radio, Included in this package – Cobra Electronics MR F80B-D User Manual

Page 11

Advertising
background image

Nothing

Comes Close to a Cobra

®

Mounting and

Powering the Radio

15

14 English

Included in this Package

Included in this Package

You should find all of the following items in the
package with your CobraMarine VHF radio:

NOTE
Cobra Accessory Harness CM 140-001 is an optional wire harness that is

used to interface the MR F80 radio with the Cobra MC 600C Series

chartplotters.

Installation and Start-Up

Installation and Start-Up

Mounting and Powering the Radio

Before using your CobraMarine VHF radio, it must be installed on your vessel.

Installing Your Radio

Choose a location for your radio where it will be conveniently accessible with the

following factors in mind:

The leads to the battery and the antenna should be as short as possible.

The antenna must be mounted at least 3 ft (0,9 m) from the transceiver.

The radio and all speakers need to be far enough from any magnetic

compass to avoid deviation due to the speaker magnet.

There needs to be free air flow around the heat-sink fins on the back

of the transceiver.

Surface Mount

A Surface Mounting kit is included with your CobraMarine VHF radio to allow its

installation on almost any flat horizontal surface.

To Mount the Transceiver

on Almost any Flat Surface:

1.

Use the mounting bracket as a template

to drill holes for the mounting screws.

2.

Attach the mounting bracket to the

chosen surface with the mounting

bracket screws and washers.

3.

Attach the transceiver to the mounting

bracket with the Tilt Lock knobs.

4.

Tilt the transceiver to a convenient

angle and tighten the Tilt Lock knobs.

Surface Mounting Kit

Tilt Lock Knobs

Transceiver

Transceiver Flush Mount Kit

16/9

Microphone

Transceiver Surface Mount Kit

Operating Instruction Manual

WARNING

This equipment is designed to generate a digital
maritime distress and safety signal to facilitate
search and rescue. To be effective as a safety
device, this equipment must be used only within
communication range of a shore-based VHF
marine channel 70 distress and safety watch
system. The range of the signal may vary out
under normal conditions should be approximately
20 nautical miles.

Warning Sticker

Power/Interface Cables

Mic Mounting Kit

MRF80BD_MANL_INSTALL:QXP-1058720374.qxp 12/9/10 10:34 AM Page 26

Advertising