ADT Security Services 6112 - Manual (Page 12)

Partially Arm the Perimeter
G I have this feature.
G I do not have this feature.
COMMAND 8 is used to arm the perimeter of your building
while the selected portions of the perimeter remain disarmed.
Perimeter zones that are not secure (faulted) when COMMAND 8
is entered are automatically bypassed, and are not included in the
system. COMMAND 8 does not arm the interior of your
building. Exit delays are provided with this arming command.
Although this command does not send a "Closing Report" to the
Central Station, it will still send alarms.
NOTE: Bypassed zones (not armed with the system) cannot be
armed again until the system has been disarmed, the zones
returned to normal, and the system is armed again. Bypassing a
zone
will compromise your protection. Enter your
personal passcode, plus| ENT|, to cancel COMMAND 8.
Application
Use this command in residential systems to arm the front of your
house while the interior and rear perimeter doors are left unarmed.
This gives you freedom of movement between the house and the
patio.
COMMAND f a
To
1 .
3.
4.
5.
arm with COMMAND 8:
Before arming with COMMAND 8, decide which zones are
to be left disarmed. Fault the zones by leaving a door or
window open. The zone(s) must remain open until after the
exit delay time expires.
2. Press the COMMAND bar. The Command Mode
indicator light comes on.
Press the key. The PERIMETER indicator light
begins to flash. This indicates that the system has begun
exit delay time. When the exit delay has expired, the
PERIMETER indicator is continuously lit.
When performing a COMMAND 8, and no zones are faulted,
or the zones return to normal before the exit delay time
expires, the system is armed as in COMMAND 3.
To disarm your security system or cancel COMMAND 8,
enter your personal passcode then press
ENT
21
Police Alert
G
I have this feature.
G
I do not have this feature.
By using COMMAND 9, you immediately send an emergency
signal to the Central Station to summon the police. If desired,
COMMAND 9 can also be programmed to sound an alarm on the
premises.
COMMAND 9
To engage COMMAND 9:
1. Press the COMMAND bar. The Command Mode
indicator light comes on.
2. Press the key.
G
My system will create an audible alarm when using this
COMMAND.
G
My system will not create an audible alarm when using this
COMMAND.
22