ADT Security Services 6112 - Manual (Page 9)

COMMAND
■I III Enable Remote Account Management |i COMMAND
O I have this feature.
O I do not have this feature.
2. Call the Central Station using this phone number:
Your security system has the ability to be managed remotely
from the Central Station without having a serviceperson on the
protected premises. By using COMMAND 4 3, you can enable
remote account management from the Central Station. Remote
account management is done with the aid of a specially equipped
computer at the Central Station.
Typical remote programming changes may include: adding or
deleting system commands, and changing personal passcodes or
entry/exit delay times.
To use COMMAND 4 3:
1. Ensure that your security system is disarmed.
3.
This number is designated for the Remote Account Manager.
You must make the call using the telephone located:
Identify yourself and your premises (account number, name,
address, etc.) and advise the operator of the programming
changes you wish to have performed.
4. When the operator directs you, enter COMMAND 4 3 at
your Command Center:
Press the
I
COMMAND
I
bar. The Command Mode
5.
6 .
indicator light comes on.
Press the key. The key, and then press the
telephone line that the call was made from is not active when
remote account management is in progress. You may hang
up the telephone.
When remote account management has been completed, your
telephone line is restored to normal service.
15
Local System Test
O I have this feature.
O I do not have this feature.
It is easy for you to test your security system without sending
reports to the Central Station. The local system test is performed
only when the security system is disarmed. To ensure that your
security system is operating properly, and should be used to test
your system regularly.
COMMAND 4 4 is used to test your security system. This
command tests your Command Center, system's sounders (both
interior and exterior) and the system's detection devices. No
alarm reports are sent to the Central Station unless a 24-hour
zone is faulted (e.g.: panic, fire, duress). (Cohtact your Central
Station before you test your fire protection system because an
alarm report may be transmitted.)
To test individual detection devices, simply activate sensors, and
open protected doors and windows'one at a time. As detection
devices are faulted, the Command Center display panel indicates
the faulted zone. This verifies that the detection device is working
properly.
COMMAND 4 4
To use Local System Test:
1. Ensure that your security system is disarmed.
3.
4.
5.
2. Press the COMMAND bar. The Command Mode
indicator light comes on.
Press the key twice. Audible devices (both interior and
exterior) sound. To silence the audible warning, press any
numeric key on the Command Center keypad.
After silencing the audible devices, you may test detection
devices. Open a door or window, or activate a motion sensor.
The Command Center display panel indicates the zone which
you have faulted. This verifies that the detection device is
working properly.
To end the Local System Test, press any numeric key on the
Command Center.
16