Audiovox ACA 240 - Manual (Page 5)

Installation Instructions
COMPLETELY READ THIS MANUAL BEFORE
INSTALLATION
NOTE; We have included all of the items needed for most standard
installations, but all vehicles are different. We recommend you review
your vehicle completely before starting.
Monitor Installation
Mounting the Monitor
The monitor with flexible mounting pad and double sided tape mounts on
either the vehicle windshield or dashboard.
Note: The double sided tape supplied is extremely strong.
Be sure of the position before mounting. The Windshield MUST be clean
and you MUST apply pressure to the mount to make sure the tape holds.
1. Choose a monitor location in your vehicle that does not block your
view and complies with local laws for safe driving..
2. Clean the monitor base and mounting area with a cleaner that does
not leave a residue.
3. Remove the protective film from one side of the double sided tape
and apply to the bottom of the monitor base. Next, remove the
protective film from the other side of the double sided tape and
carefully position the monitor and press into place.
Electrical Connections
The monitor can be powered two ways:
1. Cigarette Lighter Adapter: Plug the cigarette lighter adapter into
the vehicle's cigarette lighter socket, and then insert the 2.5mm
plug into the power supply jack on the monitor.
Note: Because this is a wireless system, the monitor is always watching
for a video signal. It is possible to receive signals from other cameras.
Systems such as Security camera's, Baby monitors, and even other Back
up camera systems can trigger the monitor to briefly turn on. This is
normal for wireless products. If you find you have too much activation
due to video signals in your area, use the included Monitor Power wire
and run it to the rear of the vehicle. Attach it to the same power source
as the camera, this will insure the monitor will only come on when you
are in reverse and will eliminate any false signals.
Testing the System
To test the Wireless Vehicle Rear Observation System installation,
perform the following steps:
1. Set the parking break.
2. Start the vehicle.
3. Shift the vehicle into reverse.
4. Verify that the monitor displays the image from the rear camera.
If the monitor does not operate, refer to the trouble shooting section of
the manual.