Audiovox ACA 240 - Manual (Page 6)

11 .
iii.
6. Using the tap connector supplied, perform the following steps:
i. Place the un-stripped positive lead wire on the run channel.
Insert the un-stripped red power wire completely.
Fold the tap connector back over the wires and make the
connection by crimping the u-contact down flush with the
plastic insulator.
iv. Close the top hinged cover until latched.
7. Attach the black wire to the ground.
i. Place the un-stripped ground lead wire on the run channel.
Insert the un-stripped black ground wire completely.
Fold the tap connector back over the wires and make the
connection by crimping the u-contact down flush with the
plastic insulator.
Close the top hinged cover until latched.
11 .
iii.
IV.
-----------
_____
—^ "F=
—^
—^
7^------
Operating the System
The Wireless Vehicle Rear Observation System operates when the
vehicle is shifted into reverse. The Camera transmits a clear and wide
image from the area behind the vehicle to the Monitor inside the vehicle.
The monitor, when powered, remains in sleep mode until it receives a
video signal on the 2.4GHz frequency. When the monitor receives a
video signal, it automatically turns on and displays the image from the
camera.
The monitor automatically adjusts for color, brightness, and contrast,
for either daytime viewing or night time viewing. At night the picture
will look more like a Black & White image; this is due to the low light
level and is normal.
2. Advanced Hard Wire Installation: Audiovox recommends using
a qualified professional for the Hard Wired cable installation.
CAUTION: Insure that all wires are run safely and do not interfere
with Airbags, Safety Devices, or any other equipment.
a) Choose a source that only has power when the vehicle ignition is
on. Check with a meter or test lamp (can be purchased at an auto
parts store). After determining your power location; turn off the
ignition and disconnect the battery to insure your safety.
b) The Red wire on the Monitor Power Harness is the ignition or +12
volt lead. This must be connected to the power source or fuse box
location that you have chosen to use. Insure the connection is
covered or protected so it can not short circuit.
c) The Black wire on the harness is to be connected to any -12 volt
ground lead or a solid metal location in the vehicle. Also test your
location to insure a good solid ground. Just because it is metal
does not mean it is a good ground.
d) Plug the power plug into the monitor power supply j ack.
After the monitor Installation is complete remove the protective plastic
cover from the panel.
NOTE: When using the Cigarette Lighter Adapter, if the Red Power
Indicator stays on after you turn your ignition key off, you will want to
unplug the adapter to insure that your vehicle battery does not run
down when parked for extended periods of time.
To replace the fuse in the Cigarette lighter adapter, unscrew the tip.
Replace only with the same rating of fuse or damage may incur.