Getting started, Preparing the rotary remote, Resetting the unit – Sony XR-3753 User Manual

Page 4: Detaching the front panel

Advertising
background image

4

EN

Attaching the front panel

Attach part A of the front panel to part B of
the unit as illustrated and push until it clicks.

Notes

Make sure the front panel is the right way up when

attaching it to the unit as it cannot be attached upside
down.

Do not press the front panel hard against the unit when

attaching it to the unit. It can easily be attached by
pressing it lightly against the unit.

When you carry the front panel with you, put it in the

supplied front panel case.

Do not press hard or give excessive pressure to the

display windows of the front panel.

Do not expose the front panel to direct sunlight, heat

sources such as hot air ducts or leave it in a humid place.
Never leave it on the dashboard etc. of a car parked in
direct sunlight where there may be a considerable rise in
temperature inside the car.

Caution alarm

If you turn the ignition key to the OFF position
without removing the front panel, the caution
alarm will beep for a few seconds (only when
the POWER SELECT switch is set to the A
position). If you connect an optional power
amplifier and do not use the built-in amplifier,
the beep tone will be disabled.

Preparing the rotary
remote

When you mount the rotary remote, attach the
label in the illustration below.

Getting Started

Resetting the unit

Before operating the unit for the first time or
after replacing the car battery, you must reset
the unit.
Press the reset button with a pointed object,
such as a ballpoint pen.

Note
Pressing the reset button will erase all the memorised
programme and memory functions.

Detaching the front panel

The front panel of this unit can be detached to
prevent the unit from being stolen.

1

Press (OFF).

2

Press (RELEASE) to open up the front
panel, and detach the panel by pulling it
towards you.

Notes
• Be sure not to drop the panel when detaching it from the

unit.

• If you press (RELEASE) to detach the panel while the

unit is still turned on, the power will automatically turn
off to protect the speakers from being damaged.

B

A

Reset button

(RELEASE)

SEL

DSPL

MODE

SEL

DSPL

MODE

Advertising
This manual is related to the following products: