Avanti DER24CSS - Manual (Page 17)

CARE AND CLEANING of YOUR RANGE
Your range is designed for easy care. This will help to keep it looking and operating like new many
years.
Surface Units and Reflector Bowls
Removing:
1 - Make sure ail surface units are off and
cool before removing surface units and ^
reflector bowls.
2- Lift the edge of unit, opposite the
receptacle, just enough to clear the
reflector bowl.
3- Pull the surface unit straight away from
the receptacle.
4- Lift out the reflector bowl
Replacing:
1- Make sure all surface units are off and cool
before removing surface units and reflector
bowls. .
2- Line up openings in the reflector bowl with
the surface unit receptacle.
3- Hold the surface unit as level as possible
with the terminal just started into the
receptacle. Push the surface unit terminal
into the receptacle.
4- When terminal is pushed into the receptacle
as far as it will go. push down the edge of
the surface unit opposite the receptacle.
Note: Do not immerse burners in water.
Surface Unit
Receptacle
Reflector Bowl
Figure 12
Lift-up Cooktop
You can reach the beneath of
cooktop for cleaning purpose by lifting
up the cooktop. In order to do:
1
-
2-
3-
4-
5-
Hold the cooktop from front left
and right corners of cooktop and
pull it up.
After lifting the cooktop high
enough, locate the support rod
and put it into place as shown in
figure 13.
Leave the cooktop on the tip of
support rod.
Wipe with warm soapy water. Use a soapy steel-wool pad on heavily soiled areas.
To lower the cooktop, lift cooktop holding from the front edge. Replace the support rod to its
previous place. Lower the cooktop in its place. During replacing the cooktop, be sure that the
front edge of cooktop covers the upper edge of control panel.
Note: Do not drop the cooktop. Personal injury or damage to the cooktop frame could result
14 i N t i .