Avanti WDR-52 - Manual (Page 6)

important Safety Instructions
y WARNING y
To reduce the risk of fire, electrical shock . or
- ‘„r/ ,vhen using your appliance, follow these
sasic precautions:
Read all instructions before using this appliance.
DANGER or WARNING: Risk of child entrapment.
Before you throw away your old refrigerator: Take off the door, Leave the shelves in
place so that children may not easily climb inside.
Never allow children to operate, play with, or crawl inside the refrigerator section.
Never clean refrigerator parts with flammacie riL:ds. The fumes can create a fire hazard or
explosion.
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this
or any other refrigerator. The fumes can create a fire hazard or explosion.
Do not plug unit into receptacle until you ensure tiie water tank switches are off.
-Save these Instructions-
INSTALLATION GUIDELINES:
Before Using Your Appliance
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
• 3 shelves in refrigerator section.
• 1 Water Collection tray
• 1 Instruction Manual
• Accessories order form.
• Before connecting the appliance to tiie power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• The water dispenser is pre-cleaned at the factory but the reservoir and water lines must be
flushed with fresh water before use as follows:
• Keep the unit unplugged,
• Fill water tank with tap water full to capacity (almost 3/4 of a gallon). Wait for 5 minutes
until water settles.
• Press the hot water faucet until water comes ouL then stop.
• Plug the dispenser into the electrical outlet. Both heating-and cooling indicator lights on
front will light up at first. We are ready : cc-¡plate the first cycle. In order to do that, wait
for the hot water indicator light to go off first (approximately 10 minutes), then wait for the
cold water indicator light to go off (another 5 minutes, approximately).
• Unplug the dispenser from the electrical outlet. Proceed to drain the water from the faucets
one at a time until no more water remains.
(Note: To facilitate this operation, use a large container),
• Then, drain any water left in the tank by opening the drain cap located on the back.
• Proceed to close the drain cap* Also make sure both faucets are in the off position.
• Place ffie 5-gatlon bottle of water on the water intake, allow water to stand for
approximately one minute,
• Turn on water faucets to insure water ficws from both faucets.
• Plug dispenser into the electrical outlet
• Now you are ready to use your water dispenser.
6