Electrical connection – Avanti WDR-52 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Installation

Of Your Appliance

• Place your appliance on a floor that is strong enough to support the dispenser when it is ftjlly

loaded. The unit is provided with four rubber feet,

• Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).

Direct sunlight may affect the acrylic coating and heat sources may increase electrical

consumption. Extreme cold ambient temperatures may also cause the appliance not to perform

properly.

Allow 2 inches of space between the appliance and the wail, which allows the proper air

circulation to cool the compressor.

• Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any

circumstances cut or remove the third (ground) prong from the power cord. Any questions

concerning power and or grounding should be directed toward a certified electrician or an

authorized Avanti Products service center.

• This appliance is not recommended for outdoor use.

• Do not locate the dispenser in area where tiie temperature may fall below freezing (32°F).

• Keep area around dispenser free of dust and dirt.

• Keep the reserve supply of water bottles away from excessive heat and light

• Never unplug the water cooler, except for maintenance.

NOTE: Your water dispenser has been cleaned and sanitized before leaving the

factory, but in case a taste problem develops, place one tablespoon of

baking soda and add tap water, Fill water tank again and repeat basic

operations previously outlined, except trun the switch marked hot "OFF" to
avoid leaving residues in hot water tank.

ATTENTION:

If you do not plan to use the water heating function for more than three days, we recommend

that you turn the hot switch to the "OFF" position.

Electrical Connection

y WARNING y

IMPROPER USE OF THE GROUNDED PLUG CAN REULT IN THE RISK OF ELECTRICAL SHOCK. IF

THE POWER CORD IS DAMAGED. HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS

SERVICE CENTER.

This appliance should be properly grounded for your safety. The power cord of this appliance

is equipped with a three-prong plug which mates with standard three prong wall outlets to

minimize the possibility of electrical shock.

Do not under any circumstances cut or remove the third ground prong from the power cord

supplied.
Plug the appliance into an exclusive properly instaited-grounded wall outiet. Do not under any

circumstances cut or remove the third (ground) prong from frie power cord. Any questions

concerning power and or grounding should be directed toward a certified electrician or an

authorized Avanti Products service center.

Use of esctension cords is not recommended.

This appliance requires a standard 115/120-voit, 60Hz electrical outlet witti three-prong

ground.

The cord should be secured behind the apciiance and not left exposed or dangling to prevent

accidental injury.
Do not use an extension cord with this appliance, if the power cord is too short, have a

qualified electrician or service technidan install an outlet near the applisnce,

7

Advertising