Chauvet DJ Equipment - Manual (Page 4)

Page 4 of 16 Arena™ Hazer 3 User Manual (Rev. 02)
Product at a Glance
Use on Dimmer  Auto Programs 
Outdoor Use  Auto-ranging Power Supply 
Sound Activated  Replaceable Fuse

DMX  User Serviceable 
Master/Slave  Duty Cycle 
Safety Notes
Please read the following notes carefully before starting to work with this
product. They include important safety information about its installation, usage,
and maintenance.
 Keep this User Manual for future consultation. If you sell this product to another
user, be sure that they also receive this document.
 Always make sure that the voltage of the outlet to which you are connecting this
product is within the range stated on the decal or rear panel of the fixture.
 This product is for indoor use only! To prevent risk of fire or shock, do not expose
this fixture to rain or moisture.
 Make sure there are no flammable materials close to the unit while operating.
 Always install this product in a location with adequate ventilation, at least 20 in (50
cm) from adjacent surfaces.
 Be sure that no ventilation slots on the unit’s housing are blocked.
 Always disconnect this product from the power source before cleaning it or
replacing fuse.
 Make sure to replace the fuse with another of the same type and rating.
 The maximum ambient temperature (Ta) is 104° F (40° C). Do not operate this
product at higher temperatures.
 In the event of a serious operating problem, stop using the unit immediately.
 Never try to repair this product. Repairs carried out by unskilled people can lead
to damage or malfunction. Please contact the nearest authorized technical
assistance center.
 Never connect this product to a dimmer pack.
 Make sure the power cord is not crimped or damaged.
 Never disconnect the power cord by pulling or tugging on the cord.
 Never carry a fixture from the power cord or any moving part. Always use the
hanging/mounting bracket or the handles.
 Always avoid direct eye exposure to the light source when this fixture is on.
 Do not touch the output nozzle on this product. It is very hot during operation and
it may remain hot for several hours after turning the unit off.
 Do not mount this product on a flammable surface (e.g., wood, linoleum, carton,
plastic, or carpet).
 Make sure there are no flammable materials close to the unit while operating.
 Depending on the amount of fog/haze generated, all fog machines may set off
smoke detectors.
FCQ (Fog Cleaner Quart) was specifically developed by Chauvet to clean your
Arena™ Hazer 3. Make sure you use FCQ regularly to increase the life of your
product.