Chauvet DJ Equipment - Manual (Page 9)

Arena™ Hazer 3 User Manual (Rev. 02) Page 9 of 16
Configuration (DMX Mode)
Setting this product to operate in DMX mode will allow you to control it with a DMX
controller.
1. Connect this product to a suitable power outlet.
2. Turn this product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the
DMX input socket of this product.
Starting Address
When selecting a starting DMX address, you must always consider the number of
DMX channels assigned to the selected DMX mode. If you choose a starting address
that is too high, you could limit the access to some of the channels of the DMX mode
in use.
The Arena™ Hazer 3 uses up to two DMX channels, which defines the highest
configurable address to 511.
If you are not familiar with the DMX protocol, you may refer to the “DMX Primer”
section in the “Technical Information” chapter.
To select the starting address, do the following:
1. Press <FUNCTION> repeatedly until DMX512 Add. shows on the display.
2. Use <UP> or <DOWN> to select the starting address.