Assembly instructions, Note – Bolens 244-642-000 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 1.
ASSEMBLY INSTRUCTIONS
CONTENTS OF HARDWARE PACK (See Figure 1):
(A) (2) Spacers
(B) (2) Tapered Roller Bearings
(C) (2) Hex Castle Nuts 3/4-16 Thread
(D) (2) Cotter Pins
(E) (2) Hubcaps
(F) (1) Shoulder Bolt
(G) (1) Flat Washer
(H) (1) Automotive Grease
(I)
(1) Tow Hitch and Stand (Not Shown - See
Figure?)
(J)
(1)
Ferrule
(K) (1) Hairpin Cotter
TOOLS REQUIRED:
(1) Raw H ide or Plastic Hammer
1-1/8" Wrench or Adjustable Wrench
3/4" Wrench
Pipe Wrench
OTHER MATERIALS NEEDED:
(A) One gallon of regular grade gasoline (for engine)
1-1/2 pints of SAE 30or 10W-30oil (for engine)
Approximately 2-1/2 gallons of Dexron II auto
matic transmission fluid. (May be obtained at
your local service station or auto parts store.)
Funnel
Pipe Sealant
(
1
)
(
1
)
(
1
)
(B)
(C)
(E)
(F)
1.
Pack the tapered roller bearings with automotive
grease.
•NOTE
Do not put any grease in the hub caps.
, 2. Place one spacer (A) on axle, then one wheel and
tapered roller bearing (B). See figures 2 and 3.
FIGURE 3.