Bolens 244-642-000 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 4.
3. Thread hex castle nut (C) on axle. Tighten castle
nut until snug, then back off approximately 1/3
turn or until one of the slots on the castle nut lines
up with hole in axle. Secure castle nut to axle
with cotter pin (D). See figure 4.
NOTE
Make certain wheel bearings were
packed with grease before assembly.
5. >
H.AMWER
FIGURE 5.
ENGAGEMENT HAND .E
ENGAGEMENT ROD
HAIR PIN COTTER
FERRULE (J)
4. Place hub cap (E) in position on wheel and tap on
with a plastic hammer. See figure 5.
5. Repeat steps 1 through 4 for the second wheel.
FIGURE 6.
6. Secure engagement handle to beam with shoulder
bolt (F) and flat washer (G). See figure 6.
7.
Thread ferrule onto engagement rod until ferrule
lines up with hole in engagement handle, with the
engagement handle placed in neutral position.
Refer to figure 10.
8.
Secure engagement rod to engagement handle
with hair pin cotter (K). See figure 6.
NOTE
For proper adjustment of stroke re
turn stop plunger, refer to page 10.
TIRE PRESSURE
FOR SHIPPING PURPOSES, THE TIRES ON YOUR
UNIT MAY BE OVER-INFLATED. TIRE PRESSURE
SHOULD BE REDUCED BEFORE UNIT IS PUT
INTO OPERATION. RECOMMENDED PRESSURE
SHOULD BE APPROXIMATELY 15 P.S.I. EQUAL
TIRE PRESSURE SHOULD BE MAINTAINED ON
ALL TIRES. MAXIMUM TIRE PRESSURE IS 30
P.S.I.